WAVIN 3/4" x 3/4" RG Angle Nipple Connector, brass/plastic plumbing fitting

WAVIN 3/4" x 3/4" RG Angle Nipple Connector is a compact plumbing fitting combining brass and engineered plastic to form a right-angle connection for 3/4" RG threaded pipes. Designed to redirect fluid flow where space is limited, this angle nipple connector creates a stable joint between two threaded ends while maintaining flow integrity in water supply and heating installations. The construction balances corrosion resistance of brass with the lightweight, durable properties of plastic components.

Advantages

The brass and plastic construction provides reliable mechanical strength and resistance to corrosion in typical potable water and heating environments. The angle configuration reduces required installation space and simplifies routing of piping runs without extensive bending. Threaded 3/4" RG connections offer familiar, serviceable joints that are easy to assemble and disassemble for maintenance. The compact design minimizes leaks when installed correctly and is compatible with standard 3/4" RG threaded fittings.

Suitable for

• Domestic water supply lines requiring a right-angle connection
• Central heating systems where space constraints demand compact fittings
• Plumbing repairs and service connections with 3/4" RG threads
• Applications needing a durable, corrosion-resistant joint

Key specifications

• Connection size: 3/4" RG threaded on both ends
• Configuration: 90-degree angle nipple connector
• Materials: brass threaded components combined with engineered plastic body/parts
• Intended media: potable water and heating fluids
• Typical applications: water supply and central heating installations

How to use

Ensure pipes and threads are clean and free of debris before installation. Apply suitable thread sealant or PTFE tape to the male threads as recommended for the system and tighten the connector by hand, then finish tightening with appropriate tools without over-torquing to avoid damaging threads or plastic components. Position the angle connector to achieve the desired routing, check alignment, and verify all joints are secure. After installation, pressurize the system and inspect for leaks at the connection points; re-tighten or reseal if necessary.

Usage recommendations

Use appropriate thread sealants compatible with potable water where required, and avoid excessive torque on plastic parts. For installations within pressurised heating systems, follow local regulations and recommended pressure/temperature limits for brass and plastic fittings. Periodically inspect threaded joints for signs of wear or leakage, and replace the connector if corrosion or damage is observed.