Electrofusion Coupler Weba 32 mm (02-01-0032-08) polyethylene pipe joint

Electrofusion Coupler Weba 32 mm is a polyethylene pipe joint designed to create leak-resistant connections for 32 mm PE pipes. The coupler incorporates an integrated heating element that, when activated by a compatible electrofusion control unit, fuses the pipe ends into a continuous, mechanically robust joint. Intended for use in water, gas distribution and low-pressure piping systems, this coupler provides consistent fusion performance when installed according to established electrofusion procedures.

Advantages

The coupler offers a compact, ready-to-install solution that eliminates the need for external fittings or solvent welding. Its integrated heating coil ensures uniform heat distribution around the pipe circumference, producing reproducible fusion results and reducing the risk of leaks. The design supports straightforward alignment of pipe ends and facilitates predictable cooling and contraction behavior, which helps maintain joint integrity under normal operating conditions.

Suitable for

• Joining 32 mm polyethylene (PE) pipes in potable water distribution networks
• Low-pressure gas distribution lines where polyethylene electrofusion is permitted
• Repairing or extending existing PE piping systems
• Small-diameter service connections and lateral branches

Key specifications

• Material: Polyethylene (PE)
• Nominal pipe size: 32 mm
• Connection method: Electrofusion with integrated heating element
• Intended pressure range: Low- to medium-pressure piping applications (as specified by system design)
• Typical application fluids: Water, gas (where permitted), and other compatible non-corrosive media

How to use

Prepare pipe ends by cutting square and removing any burrs, dirt or oxidation. Clean the pipe outer surface and chamfer if required by the electrofusion procedure. Insert both pipe ends into the coupler until they reach the specified stop position. Use a compatible electrofusion control unit to read the coupler parameters (printed on the fitting) and apply the prescribed welding cycle. Maintain alignment and avoid movement during the heating and cooling periods. After cooling, verify the joint visually and, where applicable, perform pressure testing in accordance with local codes and project requirements.

Usage recommendations

Store fittings in a dry, shaded area away from direct sunlight and sources of contamination. Use only certified electrofusion control equipment and trained personnel to perform welds. Follow the pipe manufacturer and local regulations for allowable media and pressure ratings. When in doubt, consult installation guidelines or a qualified technician to ensure safe and compliant jointing.