Anti-vibration mat wessper SIL061-10, 10 mm thickness for appliances and machinery

wessper SIL061-10 is a 10 mm anti-vibration mat designed to reduce vibration and airborne and structure-borne noise from household appliances, HVAC units and small machinery. The mat creates a stable, cushioning interface between equipment and the supporting surface, helping to dampen oscillations, limit movement and protect floors from scratches and indentations. Its compact thickness makes it suitable for placement under washing machines, tumble dryers, compressors, pumps and similar devices where vibration isolation and surface protection are required.

Advantages

The wessper anti-vibration mat delivers effective vibration absorption through a dense, resilient material that balances load-bearing capacity with damping performance. Its 10 mm thickness offers a low-profile solution that preserves appliance alignment while reducing transmitted noise and mechanical impulses. The mat is simple to cut to size if needed and is resistant to compression set under typical household and light industrial loads, providing consistent performance over time. It also prevents direct contact between metal feet and floor surfaces, reducing wear and the risk of scratching.

Suitable for

• Washing machines and tumble dryers
• Refrigeration compressors and HVAC units
• Air compressors and small workshop machinery
• Pumps, generators and other vibrating appliances
• Floor protection under appliances on tile, wood or laminate

Key specifications

• Material type: resilient anti-vibration elastomer (dense foam/rubber)
• Nominal thickness: 10 mm
• Function: vibration damping and floor protection
• Surface: non-slip texture suitable for appliance feet
• Cut-to-fit: can be trimmed with a utility knife for customised placement
• Durability: resistant to compression under typical appliance loads

How to use

Place the anti-vibration mat directly under each appliance foot or as a full mat beneath the unit, ensuring the equipment sits level and stable. Clean and dry the floor surface before installation to ensure full contact. If required, trim the mat to size with a sharp utility knife to match the appliance footprint. After positioning, run the appliance through a short operational cycle and check for stable contact and reduced vibration; adjust placement as necessary to achieve even support under all feet.

Usage recommendations

For best results, use one mat per appliance foot or a continuous mat beneath smaller units; avoid stacking multiple mats. Do not expose the mat to open flames or aggressive chemicals. Inspect periodically for excessive wear or permanent compression and replace if damping performance noticeably decreases.