Smart bulb WiZ 60 W A60 E27 White 220-240 V

The WiZ Smart bulb 60 W A60 E27 White is a smart LED lamp intended for energy-efficient general lighting in domestic and small commercial environments. The lamp delivers the equivalent light output of a conventional 60 W incandescent bulb while consuming 8.5 W of electrical power. It is designed for standard E27 screw fittings and for use on AC supplies of 220–240 V. The compact A60 form factor with a height of 122 mm and a diameter of 60 mm allows installation in most table lamps, ceiling fixtures and pendant fittings. This pack contains three identical bulbs for simultaneous installation across several luminaires.

Advantages

The WiZ bulb combines low power consumption with a familiar bulb shape and standard E27 compatibility, offering a direct replacement for traditional incandescent or halogen lamps. It supports instant start at mains voltage and stable light output suitable for everyday tasks. The smaller electrical load reduces energy costs and heat generation compared with higher‑wattage non‑LED lamps. Pack of three units simplifies multi‑point upgrades and reduces the need to purchase individual bulbs separately.

Suitable for

• General room lighting in living rooms, bedrooms and kitchens
• Desk and table lamps with E27 fittings
• Hallways, stairwells and entryways requiring standard A60 bulbs
• Small offices and reception areas with 220–240 V supply

Key specifications

• Rated power consumption: 8.5 W
• Light form factor: A60 (standard bulb shape)
• Fitting: E27 screw cap
• Operating voltage: 220–240 V AC
• Dimensions: approximately 60 mm diameter × 122 mm height
• Color: white (diffused output)
• Pack quantity: 3 bulbs

How to use

Ensure the power to the luminaire is switched off before installing the bulb. Screw the WiZ A60 E27 bulb into a compatible E27 socket until secure, then restore mains power. Operate the bulb using standard wall switches or compatible smart controls if available. The lamp is suitable for direct connection to 220–240 V supplies and requires no external driver beyond the integrated electronics. Allow a short warm‑up period for the lamp to reach its rated light output after switching on.

Usage recommendations

Use in fixtures rated for E27 bulbs and ensure adequate ventilation around the lamp to avoid heat accumulation. Avoid use in fully enclosed luminaires unless the fixture specifies compatibility with integrated LED bulbs. Replace bulbs in sets at the same time to maintain consistent light color and output across multiple fixtures.