Wybot S2 Pro is a wireless robotic pool cleaner designed to automate thorough cleaning of pool floors, walls and the waterline. The cordless, battery-powered unit features underwater wireless charging and an intelligent docking station that guides the robot back for recharge. Equipped with sonar-based underwater control and app connectivity, the S2 Pro enables remote launch, route selection and targeted area cleaning while delivering high flow suction and dual-level filtration for clear water.
Advantages
The S2 Pro uses underwater wireless charging to remove exposed ports and reduce corrosion risk, while its brushless 90 W motor offers higher efficiency, longer life and lower energy consumption. Sonar communication and an amplified docking signal provide reliable control even when the robot is submerged. A dual filtration system with a fine 180 µm filter and an ultra-fine 40 ppi sponge traps both coarse debris and fine particles. The unit combines up to 3.5 hours of operation, fast 3-hour charging, precise automatic return to dock and OTA updates for ongoing feature improvements.
Suitable for
- Residential inground and freestanding pools up to approximately 300 m²
- Pools with tile, cement, stone, fiberglass or vinyl surfaces
- Cleaning of pool floors, vertical walls and waterlines
- Scheduled or on-demand cleaning controlled via mobile app
Key specifications
- Maximum pool area coverage: up to 300 m²
- Maximum working depth: up to 3 m
- Unit dimensions: 400 × 390 × 255 mm; Robot weight ~8.5 kg, Station ~3.0 kg
- Runtime per charge: up to 3.5 hours; Charging time: ~3 hours
- Battery: rechargeable 25.9 V, 7,800 mAh
- Motor power: 90 W brushless; Water flow rate: 14 m³/h (≈3962 GPH)
- Movement speed: ~10 m/min; Protection rating: IPX8
- Filtration: two-level system (fine filter + ultra-fine sponge)
- Connectivity: mobile app control, OTA firmware updates; Sonar-enabled underwater control
How to use
Place the docking station near the pool and ensure the station is powered according to local electrical requirements. Before the first use charge the robot fully, then place it into the water and launch the WYBOT app to connect. Select the desired cleaning mode or draw a target area in the app to start targeted cleaning. The robot will scan its surroundings, plan an efficient route and clean floors, walls and the waterline autonomously. After the cleaning cycle or when battery is low, the S2 Pro will automatically return to the docking station to recharge.
Usage recommendations
For best results, remove large debris from the pool surface before running the robot, check and clean filters after heavy debris loads, and store the device and docking station according to the manufacturer’s instructions when not in use. Use recommended charging intervals and keep the app updated to benefit from OTA improvements.
