Pool cleaning robot Wybot Winny 200 wireless

Wybot Winny 200 wireless pool cleaning robot is a cordless device for automated floor and wall cleaning of residential swimming pools up to 60 m². Powered by a 3200 mAh battery, the robot operates for up to approximately 80 minutes and delivers a filtration capacity of 7.5 m³/h. With a compact, lightweight design (3.3 kg) and IPX8 waterproof rating, it can be submerged to a depth of up to 2.5 m and is suitable for routine pool maintenance without a tether.

Advantages

The Winny 200 combines cordless convenience with a two-stage filtration system that captures both larger debris and fine particles. An improved suction system rated up to 30 W prevents debris from being released back into the water, and a travel speed of approximately 16 m/min helps the robot cover pool surfaces efficiently. Smart sensor logic directs the robot to the pool wall when battery is low for easier retrieval, and the unit charges in about 4 hours with an LED charge indicator.

Suitable for

• Cleaning above-ground and in-ground residential pools up to 60 m²
• Removing leaves, sand and small debris from pool floors and walls
• Routine pool maintenance to reduce manual skimming and vacuuming
• Owners who prefer a wireless, portable cleaning solution

Key specifications

• Maximum pool area: 60 m²
• Operating time: approx. 80 minutes
• Battery capacity: 3200 mAh
• Filtration capacity: 7.5 m³/h
• Filtration type: two-stage (foam + 180 µm tray)
• Suction power: up to 30 W
• Travel speed: approx. 16 m/min
• Maximum water depth: 2.5 m
• Ingress protection: IPX8
• Charging time: approx. 4 hours
• Operating temperature (water): 10°C to 35°C
• Dimensions: 330 × 308 × 228 mm
• Weight: 3.3 kg

How to use

To start cleaning, charge the robot fully, press the power button and place the Winny 200 into the pool. The unit will begin automatic cleaning of floors and walls using its onboard navigation and suction system. When the battery is low the robot will navigate toward the pool edge and stop near the wall; use the supplied hook or handle to remove the device from the water. Remove and rinse the foam filter and 180 µm tray under running water after each use or as needed to maintain filtration performance.

Usage recommendations

For best results, pre-clear large debris from the pool surface, run the robot on a fully charged battery, and clean filters after each session. Store the robot in a dry, temperature-controlled location within the recommended storage temperature range and avoid charging or operating outside the specified temperature limits.