Wybot wireless pool cleaning robot M1 — robotic pool vacuum, cordless operation

Wybot M1 is a cordless robotic pool vacuum designed for automated debris removal in residential pools. The device delivers up to about 5 hours of operation on a single charge driven by a 120 W brushless motor and a flow rate up to 15 m³/h to remove dirt from the pool floor, walls and waterline. The unit supports six cleaning paths and seven operation modes, and is suitable for pools up to 400 sq. ft (approx. 400 m²) and depths up to 3 m.

Advantages

The Wybot M1 combines intelligent route planning with powerful suction and a two-level filtration system to capture both fine particles and larger debris. Its cordless design and 10,000 mAh battery provide extended runtime and relatively fast charging. The robot climbs walls and cleans the waterline, negotiates ramps and steps up to about 3 cm, and returns to the pool edge automatically when battery is low. App control with multiple modes and scheduling options enables hands-free, repeatable cleaning cycles.

Suitable for

• Routine cleaning of residential pools up to approximately 400 m²
• Removing leaves, sand and suspended particles from floors, walls and waterline
• Pools with vinyl, fiberglass, concrete, ceramic tile or stone surfaces
• Owners who prefer scheduled, app-controlled cleaning without cables

Key specifications

• Maximum recommended pool area: up to about 400 m²
• Maximum operating depth: up to 3 m
• Operating time: up to about 5 hours per charge
• Charging time: approx. 3.5 hours
• Battery capacity: 10,000 mAh, nominal voltage 25.5 V
• Motor power: 120 W (brushless)
• Flow capacity: up to 15 m³/h (approx. 3963 GPH)
• Movement speed: up to 10 m/min
• Filtration: two-level filtration system for fine and coarse debris
• Protection rating: IPX8 (suitable for continuous immersion)
• Dimensions: 460 × 420 × 230 mm; weight: approx. 11 kg
• App connection and OTA updates supported

How to use

Charge the Wybot M1 using the supplied charger until full (approx. 3.5 hours). Place the robot into the pool and start a cleaning cycle via the onboard controls or the mobile app. Select a mode that matches your needs (full pool, floor only, wall only, waterline, wall-then-floor, Eco Floor, or Turbo Floor) and, if desired, set a cyclic cleaning schedule in the app. The robot will navigate using its inertial and infrared sensors, follow a chosen path, and suction debris into the dual filters. After the cycle or when battery is low, retrieve the unit from the pool edge, remove and rinse the filters, and store or recharge according to the user manual.

Usage recommendations

For best results, remove large objects from the pool before operation and rinse filters after each heavy cleaning. Use the appropriate mode for the level of soiling—Eco Floor for light maintenance and Turbo Floor for intensive cleaning—and schedule regular cycles via the app to maintain consistent waterline and floor cleanliness.