Docking cradle kit Zebra CRD-NGTC5B-5SE5D for TC53/TC58 with Ethernet and five grey shims

The Zebra CRD-NGTC5B-5SE5D docking cradle kit is a five-slot Ethernet cradle designed for Zebra TC53 and TC58 mobile computers. It provides simultaneous charging and wired network connectivity for multiple devices, and comes with five grey shims pre-installed to ensure a secure fit for devices with protective boots. The kit is intended for fixed workstation, back-office, or point-of-sale environments where reliable power and stable wired data connections are required.

Advantages

This Ethernet cradle kit supports centralized charging and wired data synchronization for up to five Zebra TC53/TC58 devices in a compact footprint. The included grey shims allow correct alignment and stable seating for devices fitted with boots, reducing wear on connector contacts. The integrated Ethernet connection enables consistent network access for high-throughput data transfer and avoids reliance on wireless signals where stability or security are concerns.

Suitable for

• Multi-device charging and wired synchronization in warehouses and retail back offices
• Point-of-sale or checkout stations that require reliable wired network access
• Service desks and fixed workstations where multiple TC53/TC58 units need organized charging
• Environments where devices use protective boots and require shims for correct seating

When it may not be suitable

This cradle kit is specifically shaped for Zebra TC53 and TC58 models and their variants; it may not fit other device models or brands. If your workflow relies solely on wireless network connectivity or you need a portable single-device charger, a dedicated wireless or single-slot charging accessory may be more appropriate.

Key specifications

• Slots: five-device charging cradle
• Connectivity: wired Ethernet network interface for integrated network access
• Compatibility: designed for Zebra TC53 and TC58 mobile computers (including specified rugged variants)
• Shims: five grey shims pre-installed to accommodate devices with boots
• Power: includes power supply and DC cable for simultaneous charging

How to use

Place the cradle on a stable surface near an Ethernet port and power outlet. Connect the included DC cable to the power supply and plug it into the cradle, then connect the Ethernet cable to your network. Insert each TC53 or TC58 device into an available slot, ensuring the device seats securely against the pre-installed grey shims. Devices will charge and, when configured on the network, synchronize data over the wired connection. Remove devices by gently lifting them from the slot once charging or data transfer is complete.

What to consider before purchase

• Confirm device compatibility with Zebra TC53 and TC58 models and any variant you use
• Verify available Ethernet and power outlets at the intended installation site
• Check that the included shims accommodate any protective boot used on your devices
• Assess whether a five-slot fixed cradle meets your simultaneous charging needs

Usage recommendations

For reliable operation, use the cradle on a level surface, keep contact areas clean, and ensure firmware or device settings allow wired synchronization. If devices remain in boots, confirm that the pre-installed grey shims provide full contact; replace or adjust shims only with manufacturer-approved components.