Brad point drill bit DeWALT DT4516, length 165 mm, 1 pc

Brad point drill bit DeWALT DT4516, length 165 mm, 1 pc is a single brad point bit designed for precise wood drilling. Made for plywood and natural hard and softwood, this 165 mm-long bit produces clean entry holes with reduced splintering and is suitable for both handheld and stationary drills. The centering point and peripheral cutting edges enable accurate through-holes, dowel preparation, hinge installation and a range of general woodworking tasks.

Advantages

The brad point tip provides accurate centering at the start of the cut, while the two shoulders and peripheral cutting edges ensure controlled chip removal and cleaner hole walls. Constructed from chrome-vanadium-alloyed steel, the bit offers consistent cutting performance and wear resistance appropriate for repeated woodworking use. Supplied as a single 165 mm length piece, it is convenient for jobs requiring deeper penetration than standard short bits.

Suitable for

• Drilling dowel holes in furniture and joinery
• Creating through-holes in plywood and solid wood
• Preparing hinge pockets and hardware mountings
• General woodworking tasks requiring clean entry and exit holes

Key specifications

• Type: Brad point (centering) drill bit
• Material: Chrome-vanadium-alloyed steel
• Length: 165 mm
• Pack quantity: 1 piece
• Suitable materials: Plywood, natural hardwood, natural softwood
• Design features: Centering point, two shoulders, peripheral cutting edges

How to use

Secure the drill bit properly in the chuck of a handheld or stationary drill. Start drilling at low speed to allow the brad point to locate accurately, then increase speed to a level appropriate for the wood species being drilled. Apply steady, moderate pressure and clear chips as necessary to avoid clogging. For through-holes, support the workpiece where possible to reduce exit splintering. After use, clean the bit and store it dry to maintain cutting performance.

Usage recommendations

For best results, select a drilling speed suited to the wood type: slower for hardwoods and higher for softwoods. When drilling delicate veneers or thin plywood, back the workpiece with sacrificial scrap to prevent tear-out.