3D pen 3DOODLER Start Plus — FFF, 2.5 mm filament, 0.77 mm nozzle, USB, battery alkaline, max tip 65°C, for ages 6+, turquoise/yellow

3Doodler Start Plus is a child-focused 3D pen that uses biodegradable ECO‑cartridges to create low‑temperature plastic lines that solidify within seconds, allowing safe hand‑shaping. The pen is portable, charges via USB and can operate wirelessly for approximately 45–60 minutes on a full charge. The kit includes the 3Doodler Start Plus pen, two packs (48 pieces) of ECO cartridges, a USB cable and a Polish instruction booklet with project ideas.

Advantages

The plastic extruded by the 3Doodler Start Plus is warm but not hot, enabling children to shape finished lines by hand without risk of burns. ECO‑cartridges are non‑toxic, BPA‑free and fully biodegradable, and the pen has simple LED indicators for heating, ready and charging states. A 0.77 mm nozzle, low working temperature (about 65 °C) and a compact, lightweight body make the pen easy to hold and use for extended creative sessions.

Suitable for

• Children’s creative play and educational STEAM activities
• Simple 3D modelling and prototyping without computer software
• Crafts, decorations and small repair tasks

Key specifications

• Printing material: ECO‑cartridges (biodegradable, non‑toxic, BPA‑free)
• Heating temperature: 65 °C
• Nozzle diameter: 0.77 mm
• Print speed: 10 mm/s
• Single cartridge length after remelting: 150 cm; cartridge physical length: 15 cm; cartridge diameter: 2.5 mm
• Wireless working time (fully charged): 45–60 min
• Maximum power: 5 W; Power supply: 5 V (USB)
• Product dimensions: 138 x 35 x 41 mm; Product weight: 91 g
• Package dimensions: 220 x 190 x 70 mm; Package weight: 463 g

How to use

Slide the launch button to turn the pen on and wait about one minute for warm‑up. Insert a chosen ECO cartridge into the refill slot and press until you feel resistance. Press the cartridge eject button once to start extrusion and again to stop; a quick double‑click retracts the cartridge. The cartridge takes 10–15 seconds to heat up before you can draw in 3D. Use the LEDs to monitor status: red for heating, green when ready, and yellow while charging. You can use the pen while connected to power or wirelessly after charging.

Usage recommendations

For safe and consistent results, use only official 3Doodler Start ECO‑cartridges and allow the pen to reach operating temperature before drawing. Supervise young children during use and store cartridges and the pen according to manufacturer instructions.