LED strip ABILITE SMD5050 5 m, 60 LEDs/m, 40 W/m, 12 V

Flexible LED strip ABILITE SMD5050 5 m, 60 LEDs/m, 40 W/m, 12 V is a continuous, high-density lighting ribbon designed for interior accent, task and decorative lighting. The strip uses SMD5050 diodes with a high luminous flux per LED and comes in a 5 metre length with 60 diodes per metre. It is powered by 12 V DC and supplied with segments that can be cut at designated points; an adhesive backing simplifies surface mounting on suitable clean, dry substrates.

Advantages

The ABILITE SMD5050 strip delivers strong, even illumination thanks to densely spaced SMD5050 LEDs and a rated power of 40 W per metre, providing consistent brightness along its length. Its flexible construction and cut-to-length design allow adaptation to a variety of installation situations, while the self-adhesive backing and low-voltage 12 V operation make installation straightforward and compatible with common LED drivers and controllers. The product is intended for indoor use where robust light output and simple mounting are required.

Suitable for

• Accent lighting for coves, shelves and display cases
• Under-cabinet and task lighting in kitchens and workspaces
• Decorative illumination in commercial interiors and retail displays
• Backlighting for panels, signs and architectural details

Key specifications

• LED type: SMD5050 high-density diodes
• Length: 5 metres
• LED density: 60 LEDs per metre
• Power consumption: 40 W per metre
• Operating voltage: 12 V DC
• Mounting: flexible strip with adhesive backing
• Cuttable segments: yes, at marked intervals

How to use

Plan the installation route and measure the required length. Cut the strip only at the marked cut points to maintain correct electrical segments. Clean and dry the mounting surface before removing the adhesive liner and press the strip firmly into place. Connect the strip to a compatible 12 V DC power supply or controller, observing correct polarity. For runs longer than the recommended length for a single power feed, provide additional feeds or use appropriate wiring to avoid voltage drop. Avoid exposure to water and excessive heat unless the product variant is specified for wet environments.

Usage recommendations

Use a matched 12 V LED driver with adequate wattage capacity (total strip length multiplied by 40 W/m) and consider dimming controllers or RGBW controllers if colour or dimming control is required. For best results, affix the strip to flat, clean surfaces and allow for cooling space to maintain performance and longevity.