Drill bit Abraboro SDS-Plus for concrete 8 mm x 100/160 mm, 3‑cutting edges

The Abraboro SDS-Plus drill bit for concrete is designed for drilling in reinforced and non-reinforced concrete. With an 8 mm shank diameter and a working length of 100 mm (total length 160 mm), this drill bit fits SDS-Plus rotary hammer drills and is intended for tasks such as creating holes for anchors, fasteners and conduit runs. The three-cutting-edge carbide tip improves chiseling action and supports efficient dust evacuation during rotary and hammer drilling modes.

Advantages

The 3‑cutting-edge carbide tip provides stable centreing, reduced walking and consistent hole quality in concrete. The SDS-Plus shank allows quick and secure tool changes and reliable transmission of hammering energy. The combination of an optimized flute geometry and robust carbide tip helps to evacuate dust and debris, which supports faster drilling and longer bit life under typical jobsite conditions.

Suitable for

• Drilling holes for anchors and expansion bolts in reinforced and non-reinforced concrete
• Preparing openings for electrical and plumbing conduit
• Installing fastenings for structural and non-structural fixtures
• General purpose concrete drilling with SDS-Plus rotary hammer drills

Key specifications

• Shank type: SDS-Plus compatible
• Shank diameter: 8 mm
• Working length: 100 mm
• Total length: 160 mm
• Tip design: 3‑cutting-edge carbide tip for concrete
• Intended material: reinforced and non-reinforced concrete

How to use

Insert the Abraboro SDS-Plus drill bit into the rotary hammer chuck until it locks. Select the appropriate drill mode (rotary hammer) on the machine, set the correct speed and feed pressure for 8 mm diameter drilling in concrete, and position the bit at the marked point. Apply steady, moderate pressure without forcing the bit; allow the hammer action to perform the cutting. Withdraw periodically to clear dust when drilling deeper holes and to prevent overheating.

Usage recommendations

Use personal protective equipment such as safety glasses, gloves and hearing protection. For best results, use a rotary hammer with SDS-Plus interface and select an appropriate impact energy for masonry/concrete work. Replace the bit if tip damage or pronounced wear is visible to maintain hole accuracy and operator safety.