Diamond Cutting Disc Abraboro 125 mm Ø, Bore 22/12 mm, Model N5 (AB12500005)

Abraboro diamond cutting disc 125 mm Ø with a dual bore (22/12 mm), model N5, is a thin, high-hardness cutting wheel intended for abrasive cutting of stone, concrete, ceramic tiles and similar mineral-based materials. The disc features a continuous diamond cutting edge engineered for straight, precise cuts and consistent performance during repeated use. Its dual bore design allows compatibility with angle grinders that accept either 22 mm or 12 mm arbors when used with the appropriate flange or adapter.

Advantages

The diamond cutting edge delivers increased cutting speed and extended service life compared with non-diamond abrasive wheels. The 125 mm diameter offers a balance between maneuverability and cutting depth suitable for common construction and tiling tasks. A thin kerf reduces material waste and minimizes required power, while the dual bore configuration improves mounting flexibility across a range of angle grinder spindles. The N5 segment profile is designed to maintain stable cutting performance on hard mineral surfaces.

Suitable for

• Cutting natural stone and engineered stone slabs
• Trimming and cutting concrete, bricks and blocks
• Cutting ceramic and porcelain tiles
• On-site construction and renovation tasks with angle grinders

Key specifications

• Diameter: 125 mm
• Bore sizes: 22 mm and 12 mm (dual bore)
• Cutting edge: continuous diamond rim
• Intended materials: stone, concrete, tiles and similar mineral-based materials
• Profile: N5 segment/design for straight cuts
• Typical use: hand-held angle grinders with appropriate flange/adaptor

How to use

Fit the disc to an angle grinder using the correct flange or adapter for either a 22 mm or 12 mm spindle. Ensure the disc is mounted so that the rotation direction matches the arrow on the disc. Secure the mounting flange and check that the disc runs true before starting. When cutting, use steady, moderate feed pressure and allow the diamond edge to cut without forcing; excessive force can reduce life and cause overheating. Use continuous or intermittent cutting techniques appropriate to the material to avoid binding. Replace the disc if any cracks, severe wear or wobble are detected.

Usage recommendations

Use appropriate personal protective equipment including eye protection, hearing protection and dust mask. For wet cutting applications, follow tool and disc manufacturer guidelines; for dry cutting, allow frequent pauses to prevent overheating and reduce dust exposure by using local extraction where possible.