Hole Saw Abraboro SDS-Plus 66 mm Abraboro — 66 mm cutting diameter, SDS-Plus shank

The Abraboro SDS-Plus 66 mm hole saw is designed for drilling large-diameter openings in masonry and concrete when used with SDS-Plus rotary drills and rotary hammers. With a 66 mm cutting diameter and an SDS-Plus shank it provides a stable connection to the tool and is intended for creating accurate round holes for pipes, conduits and fixtures in walls and other solid masonry substrates.

Advantages

This hole saw combines a robust cutting diameter with an SDS-Plus shank to ensure reliable tool engagement and reduced slippage during heavy-duty drilling. Its design focuses on efficient material removal in masonry and concrete, delivering consistent hole size and alignment. The construction supports repeated professional and DIY use where precise circular openings are required.

Suitable for

• Creating openings for plumbing pipes and electrical conduits in masonry walls
• Installing wall fixtures, ventilation ducting or cable passthroughs
• Drilling large holes in concrete, brick and block for construction and renovation tasks

Key specifications

• Cutting diameter: 66 mm
• Shank type: SDS-Plus
• Primary materials: masonry and concrete
• Compatibility: SDS-Plus rotary drills and rotary hammers

How to use

Select an appropriate SDS-Plus rotary drill or rotary hammer and fit the Abraboro 66 mm hole saw onto the tool's shank until it locks securely. Mark the center point of the required hole and position the pilot or guide if available. Begin drilling at low speed to establish the starting position, then apply steady pressure and increase the drilling force and speed according to the drill manufacturer’s guidance for masonry. Periodically withdraw the saw to clear debris and prevent overheating. After cutting through the material, stop the tool, allow the bit to cool if necessary, and remove the hole saw by releasing the SDS-Plus connection.

Usage recommendations

Use appropriate personal protective equipment including eye protection, hearing protection and dust mask. For best results in reinforced concrete or highly abrasive masonry, use controlled pressure, moderate speed settings and clear dust frequently. Ensure the rotary drill or hammer is rated for use with SDS-Plus accessories and check tool instructions for recommended operating parameters.