Ultrasonic Cleaning Fluid AG TermoPasty TERMOSONIK‑PCB/1000 — 1000 ml metal canister

AG TermoPasty TERMOSONIK‑PCB/1000 is a liquid cleaning agent formulated for use in ultrasonic cleaners and supplied in a 1000 ml metal canister. It is intended for the safe and effective removal of flux residues, oils and light contaminants from printed circuit boards and other delicate electronic components. The composition is suited to ultrasonic bath operation, allowing cleaning by cavitation without mechanical abrasion to component surfaces or solder joints.

Advantages

The fluid is optimized for compatibility with electronic assemblies, providing thorough cleaning of fine-pitch components and populated boards while preserving solder masks and component markings. Its formulation supports efficient contaminant removal in a short cycle time and is compatible with standard ultrasonic cleaning equipment. The metal canister ensures secure storage and controlled dispensing for workshop use.

Suitable for

• Cleaning assembled printed circuit boards and electronic modules in ultrasonic baths
• Removing flux residues after soldering and rework
• Maintenance cleaning of connectors, sockets and small mechanical parts
• Preparation of components before inspection or rework

Key specifications

• Form: ready-to-use liquid concentrate for ultrasonic cleaning
• Volume: 1000 ml canister
• Container: metal canister for safe storage and dispensing
• Application method: dilution or direct use in ultrasonic baths per equipment guidance
• Suitable surfaces: PCBs, electronic components, connectors and small metal parts

How to use

Use the cleaning fluid in accordance with the ultrasonic cleaner manufacturer’s instructions. For most ultrasonic baths, add the recommended amount of fluid to the tank or use as supplied if specified by the equipment. Place circuit boards and parts in suitable baskets or fixtures to prevent direct contact with tank walls. Operate the ultrasonic cycle for the time required to remove residues, then rinse parts with deionized or distilled water if necessary and allow to dry completely before power-up or reassembly.

Usage recommendations

Observe safety data and local regulations when handling and disposing of spent cleaning solution. Avoid prolonged immersion of components with moisture-sensitive elements unless followed by appropriate drying. Test compatibility on a representative sample if uncertain about specific board coatings or materials.