Floor paint AKSIL AKSILBET RAL 7037 grey, 5 L

AKSIL AKSILBET RAL 7037 grey, 5 L is a pigmented floor paint formulated for use on interior and exterior concrete and cement surfaces. Supplied in a 5‑liter can, the paint delivers a dust‑grey RAL 7037 finish designed for garages, warehouses, workshops and residential floors where a durable, washable coating is required. The product is intended to form a protective pigmented layer over new or prepared substrates, improving surface appearance and providing a degree of mechanical and chemical resistance appropriate for typical foot and light wheeled traffic.

Advantages

The paint offers a uniform pigmented finish in RAL 7037 that conceals minor surface imperfections and evens out colour across concrete and cement floors. It is supplied in a practical 5 L size suitable for medium‑sized areas and provides a surface that is easier to clean than bare concrete. The formulation is suitable for indoor and outdoor application and is compatible with typical floor preparation methods such as cleaning, degreasing and light mechanical abrasion.

Suitable for

• Garage floors and parking areas with pedestrian and light wheeled traffic
• Workshops and production areas where a pigmented, washable surface is required
• Warehouse floors and storage rooms
• Residential basements, cellars and utility rooms

When it may not be suitable

This floor paint is not intended for surfaces subjected to heavy continuous vehicular loads, high impact abrasion or where chemical spills of aggressive solvents or concentrated acids are expected. It may not be appropriate for substrates that are structurally unsound, highly contaminated with oil or where strong moisture vapour transmission from the substrate exists unless correct surface preparation and priming measures are taken.

Key specifications

• Colour: RAL 7037 (dusty grey)
• Volume: 5 litres
• Intended substrates: interior and exterior concrete and cement floors
• Recommended traffic: foot traffic and light wheeled loads
• Finish: pigmented, washable surface

How to use

Prepare the surface by removing dust, loose particles, grease and other contaminants. Repair any structural cracks or spalled areas and allow repairs to cure. For best adhesion, mechanically abrade or shotblast the surface where feasible and then clean thoroughly. If required, apply a compatible primer according to primer manufacturer instructions and allow it to dry. Stir the paint thoroughly before use. Apply evenly with a roller or brush in thin coats; if required, apply a second coat after the first coat has dried sufficiently. Allow the final coat to cure fully before subjecting the floor to traffic; follow ambient temperature and humidity recommendations on the technical information sheet for drying and curing times.

What to consider before purchase

• Ensure RAL 7037 (dusty grey) is the desired colour for your project and order sufficient quantity for surface area and number of coats.
• Check substrate condition: clean, dry and structurally sound surfaces provide the best results.
• Plan for surface preparation (cleaning, degreasing, repair, abrasion) and any primer required for adhesion.
• Account for drying and curing times before allowing foot or wheeled traffic.

Usage recommendations

Use protective equipment during surface preparation and application. Test a small inconspicuous area first to confirm adhesion and final appearance on your specific substrate. For higher mechanical or chemical resistance requirements, consider an industrial epoxy or polyurethane floor coating system instead of a standard floor paint.