Power cable Akyga AK-OT-05A CEE 7/16 to open end 2x0.75 mm² 1.5 m

Akyga AK-OT-05A is a 1.5 m mains power lead with a CEE 7/16 (Europlug) on one end and an open, unterminated opposite end. The cable contains two conductors of 0.75 mm² in a flexible PVC jacket, allowing direct connection to terminal blocks, screw connectors or device wiring where a Europlug input is required. It is intended for simple replacement of damaged leads, appliance repairs and custom installations that need a short, ready-to-wire power lead.

Advantages

The cable combines a compact Europlug connector with an open end for flexible wiring, making it easy to adapt to different appliances and terminal types. Its 1.5 m length provides sufficient reach for most household and light-commercial setups without excess slack. The 2x0.75 mm² conductor cross-section is suitable for low-power devices and small appliances, while the PVC insulation offers basic mechanical protection and electrical insulation for everyday use.

Suitable for

• Repairing or replacing damaged power leads on small appliances and consumer electronics
• Custom wiring to terminal blocks, screw connectors or internal device wiring
• Prototyping and temporary installations where a Europlug connection is needed
• Connecting low-power devices that accept a CEE 7/16 (Europlug) input

Key specifications

• Connector type (one end): CEE 7/16 (Europlug)
• Other end: open, unterminated conductors for direct wiring
• Conductor configuration: 2 cores, 0.75 mm² each
• Cable length: 1.5 m
• Insulation/jacket material: PVC
• Intended use: low-power appliances and consumer electronics

How to use

Before installation, ensure the mains supply is switched off and verify that the cable's conductor size and Europlug type are appropriate for the intended device. Strip the insulation from the open conductors to the required length, taking care not to damage the copper strands. Securely attach each conductor to the device terminal or connector, observing correct polarity and any protective earth requirements of the appliance. After wiring, check all connections for firmness and insulate exposed conductors as needed with appropriate terminals or heat-shrink tubing. Only use the cable with equipment rated for the conductor size and Europlug connection.

Usage recommendations

Use the cable for low-power appliances and short runs; do not use it where higher current capacity or reinforced insulation is required. For permanent or high-load installations choose a cable with a larger conductor cross-section and appropriate protective features. When in doubt, consult a qualified electrician for wiring and safety compliance.