Leave your address - as soon as the price of the product goes down, you'll know about it right away
Power cable Akyga AK-RD-01A, CEE7/16 to IEC C7, 1.5 m, black, 250 V 2.5 A
Power cable Akyga AK-RD-01A, CEE7/16 to IEC C7, 1.5 m, black, 250 V 2.5 A
In cart {{totalProductsCount}} item(s)
Your cart is empty
Power cable Akyga AK-RD-01A, CEE7/16 to IEC C7, 1.5 m, black, 250 V 2.5 A
Leave your address - as soon as the price of the product goes down, you'll know about it right away
Power cable Akyga AK-RD-01A, CEE7/16 to IEC C7, 1.5 m, black, 250 V 2.5 A
Power cable Akyga AK-RD-01A, CEE7/16 to IEC C7, 1.5 m, black, 250 V 2.5 A
Akyga AK-RD-01A is a 1.5 m power cable with a CEE7/16 (Europlug) mains connector on one end and an IEC C7 (figure‑8) connector on the other. The cable is intended for devices that require a non-polarized figure‑8 lead and is rated for 250 V and 2.5 A. Its black jacket and lightweight construction make it suitable for routing behind small electronics and keeping connections tidy in home and office environments.
The Akyga AK-RD-01A provides a standard, interchangeable connection between European mains outlets and equipment with an IEC C7 inlet. Its 1.5 m length offers sufficient reach for common setups without excessive slack. The cable’s black outer jacket resists visible dirt and blends with most consumer electronics. With a rated voltage of 250 V and current of 2.5 A, it meets typical requirements for radios, chargers, portable media players and similar low‑power devices.
Ensure the device to be powered accepts an IEC C7 inlet and that its rated voltage and current do not exceed 250 V and 2.5 A. Insert the IEC C7 connector firmly into the device’s power inlet, then plug the CEE7/16 Europlug into a compatible mains socket. Route the cable to avoid sharp bends, pinch points and hot surfaces. Disconnect the cable by pulling the plug rather than tugging on the cable jacket to reduce strain on the connectors.
Use the cable with low‑power appliances and consumer electronics only. Do not use the cable if the jacket or connectors are damaged, and avoid using in damp or wet conditions. Store the cable coiled without tight kinks and replace if any signs of wear or overheating appear.
{{highlightedFeature.featureTitle}}:
{{getProductFeatureValueById(product, highlightedFeature.featureId)}}