Hook Bolt ALPAR M16 L-300 OC zinc-plated (S3013) threaded hook fastener

ALPAR hook bolt M16 L-300 OC (S3013) is a zinc-plated threaded hook fastener with an M16 nominal diameter and a 300 mm overall length. The bolt has a hooked end designed to retain cables, pipes or structural elements without additional end fittings. The zinc plating provides basic corrosion resistance for indoor and many outdoor applications, while the metric M16 thread accommodates standard nuts, washers and anchor fittings.

Advantages

This hook bolt combines a strong M16 threaded shank with a formed hook end to enable secure anchoring and hanging. Zinc plating offers protection against rust and extends service life in non-aggressive environments. The 300 mm length provides ample reach for fastening through panels, beams or masonry where a hooked termination is required. Standard metric threading simplifies installation with commonly available fastening hardware.

Suitable for

• Securing and suspending electrical or data cables
• Supporting pipes and conduit runs
• Fastening fixtures to structural elements in construction
• Temporary or semi-permanent anchoring in workshops and industrial sites

Key specifications

• Nominal diameter: M16
• Overall length: 300 mm
• Surface finish: zinc plating (corrosion-resistant coating)
• Thread form: standard metric thread suitable for M16 nuts and anchors
• End form: formed hook for retaining and suspending components

How to use

Drill or prepare a through-hole or anchor point appropriate for the chosen anchor or nut. Insert the threaded shank of the hook bolt through the material or anchor, then engage an M16 nut and appropriate washer or anchor fitting on the opposite side. Tighten to the required torque specified for M16 fasteners and verify the hook orientation to ensure the retained cable, pipe or component seats correctly in the hook. For use with masonry or hollow substrates, select a compatible anchor sleeve or chemical anchor designed for M16 bolts.

Usage recommendations

Use the zinc-plated hook bolt in environments that are not exposed to aggressive chemicals or continuous salt spray; for marine or highly corrosive conditions select a stainless steel or higher-grade coated fastener. Always match the bolt length and thread engagement to the anchor system and load requirements, and follow relevant building codes and manufacturer torque values when installing.