Filter element AMG water filters FA 10, 25 micron filtration, replacement cartridge

Replacement filter element AMG water filters FA 10 with 25‑micron filtration. This spun polypropylene cartridge is intended for use in compatible AMG FA 10 housings for residential and light commercial water treatment. It captures particulate contaminants down to 25 µm, offers high contaminant retention capacity, and supports high flow rates with minimal pressure drop. The cartridge has an outer diameter of 61 mm and an inner diameter of 28 mm and is suitable for treatment of both potable and non‑potable raw water. Maximum operating temperature is +80°C.

Advantages

The polypropylene wound construction provides effective particle trapping and good mechanical strength. High dirt‑holding capacity extends service life between changes, while the design ensures a large flow with low pressure loss. Materials are compatible with potable and non‑potable water applications and the cartridge fits standard AMG FA 10 housings.

Suitable for

• Removal of suspended solids from primary raw water
• Pre‑filtration to protect downstream equipment (pumps, valves, membranes)
• Residential water filtration systems
• Light commercial and industrial water treatment where 25 µm particulate removal is required

Key specifications

• Filtration rating: 25 micron (25 µm)
• Material: spun polypropylene wound cartridge with polypropylene core
• Outer diameter: 61 mm (2.4 in)
• Inner diameter: 28 mm (1.1 in)
• Maximum operating temperature: +80°C
• Compatible with: AMG FA 10 housings

How to use

Install the replacement cartridge into a compatible AMG FA 10 housing following the housing manufacturer’s instructions. Ensure system is depressurized before opening the housing. Insert the cartridge onto the housing support tube, close and tighten the housing, then gradually restore pressure and check for leaks. Replace the cartridge according to observed pressure drop or scheduled maintenance intervals.

Usage recommendations

For optimal performance, flush new cartridges briefly before use to remove loose fibers. Monitor differential pressure to determine replacement frequency and avoid exceeding the maximum operating temperature of +80°C.