Drill bit Art-Pol ARTPOL WIERTŁO SDS PLUS 28x1000mm

The Art-Pol ARTPOL WIERTŁO SDS Plus 28x1000mm is a long-reach SDS Plus drill bit designed for drilling deep holes in concrete, masonry and natural stone. With a 28 mm cutting diameter and a 1000 mm overall length, this bit is intended for use with SDS Plus rotary hammers where extended reach and reliable performance are required. The carbide tip and flute geometry are engineered to evacuate dust and break material effectively during deep drilling operations.

Advantages

This SDS Plus drill bit offers stable centring and consistent hole diameter throughout its length, reducing the need for re-drilling. Its long 1000 mm length provides access to recessed or hard-to-reach areas without extensions, and the 28 mm diameter balances material removal rate with structural accuracy. The bit is compatible with standard SDS Plus chucks and suitable for both professional and home workshop applications where durable deep-drilling tools are needed.

Suitable for

• Drilling deep holes in reinforced concrete and structural masonry
• Installation of anchor bolts and long dowels
• Through-holes for conduit, plumbing or cable runs in walls
• Renovation and construction tasks requiring extended reach

Key specifications

• Shank type: SDS Plus compatible shank for rotary hammers
• Cutting diameter: 28 mm
• Total length: 1000 mm for deep-drilling access
• Suitable materials: concrete, masonry, natural stone
• Tip material: carbide tip for increased wear resistance

How to use

Install the ARTPOL WIERTŁO into an SDS Plus rotary hammer according to the tool manufacturer’s instructions, ensuring the shank locks securely in the chuck. Mark the drilling location, start the hammer at low speed to establish the pilot position, then apply steady pressure while allowing the hammer action to do the cutting. Periodically withdraw the bit to clear dust and debris from the hole if drilling long depths. Use appropriate personal protective equipment, including eye protection, hearing protection and dust mask when drilling.

Usage recommendations

For best results, match drill speed and hammer setting to the material being worked: use full hammer action for concrete and reduced feed pressure when approaching rebar. If drilling very deep holes, clear debris regularly and inspect the carbide tip for wear; replace the bit when the cutting performance declines to maintain hole accuracy.