Drill bit Art-Pol SDS+ 6 mm AR48006 for concrete

Drill bit Art-Pol SDS+ 6 mm AR48006 for concrete is a purpose-built rotary hammer accessory for creating precise holes in concrete, brick and masonry. Designed to fit SDS+ chucks, this 6 mm diameter bit supports percussion drilling in SDS+ rotary hammer systems to deliver consistent results for anchor installation, conduit routing and general fastening tasks. The bit's geometry and material selection focus on durability and efficient dust evacuation during drilling in hard substrates.

Advantages

The SDS+ 6 mm drill bit provides reliable drilling performance with a compact diameter that minimises material removal while maintaining hole accuracy. Its SDS+ shank ensures secure, backlash-free engagement with compatible rotary hammers, translating impact energy effectively to the carbide tip. The bit design promotes chip removal to reduce clogging and heat build-up, extending service life during repeated use in masonry and concrete.

Suitable for

• Drilling anchor holes for bolts and screws in concrete and brick
• Creating passages for electrical conduits and plumbing in masonry walls
• Installing wall plugs, anchors and fastenings
• General light to medium-duty percussion drilling tasks in construction and renovation

Key specifications

• Shank type: SDS+ compatible
• Drill diameter: 6 mm
• Intended material: concrete, brick, masonry, natural stone
• Suitable tool type: SDS+ rotary hammer
• Typical use: percussion/drilling hammer mode

How to use

Insert the SDS+ shank fully into the rotary hammer chuck until it locks. Select the hammer drilling mode on the tool and position the bit tip on the marked drilling point. Apply steady axial pressure while allowing the tool's percussion action to work; avoid excessive force that can cause bit wear or tool stalling. Periodically withdraw the bit to clear dust and debris from the hole for improved cutting efficiency and cooling. Use appropriate personal protective equipment such as safety glasses, hearing protection and a dust mask when drilling.

Usage recommendations

For best results, match drill speed and pressure to substrate hardness, pre-mark hole depth if precision is required, and use a vacuum or dust extraction when working indoors to control debris. Replace the bit when performance declines to maintain clean, accurate holes.