Drill Bit Art-Pol SDS+ 8 mm AR48058 for Concrete

Art-Pol SDS+ 8 mm AR48058 for Concrete is a drill bit designed for rotary hammers with an SDS+ chuck, intended for drilling into concrete and masonry. With an 8 mm diameter, it is suitable for creating anchor and fastening holes where accurate diameter and reliable penetration are required. The bit combines rotary and percussive action to remove material efficiently and maintain consistent hole size in reinforced and non-reinforced concrete.

Advantages

The SDS+ shank ensures quick and secure tool engagement and reduces slippage during percussive drilling. The carbide tip geometry improves cutting performance and wear resistance when used in concrete and masonry. A balanced flute design promotes effective dust and debris evacuation from the hole, helping to maintain drilling speed and prolong tool life. The 8 mm diameter provides a common, precise size for anchors and fixings.

Suitable for

• Drilling anchor and fastening holes in concrete
• Masonry drilling for installations and fixture mounting
• Preparing holes for wall plugs and expansion anchors
• Use with SDS+ rotary hammers on construction sites and DIY projects

Key specifications

• Tip material: carbide tip for concrete and masonry
• Shank type: SDS+ for compatible rotary hammers
• Diameter: 8 mm for standard anchor sizes
• Intended use: rotary and percussive drilling in concrete and masonry
• Flute design: spiral flutes for dust removal and consistent cutting

How to use

Fit the drill bit into the SDS+ chuck of a compatible rotary hammer and ensure it is locked securely before operation. Select rotary-percussive mode for concrete and masonry drilling. Mark the drilling point, start at low speed to establish a pilot notch if needed, then apply steady axial pressure while maintaining tool alignment. Use intermittent withdrawal to clear debris from the hole for deeper drilling. After use, clean the flutes and inspect the carbide tip for wear.

Usage recommendations

Use appropriate personal protective equipment such as safety glasses and hearing protection. For reinforced concrete, reduce pressure around rebar and resume moderate speed to prevent tip damage. Replace the bit when the carbide tip shows significant wear or when drilling efficiency decreases to maintain accurate hole size.