Drill Bit Art-Pol AR48260 SDS+ 10 mm for Concrete

Art-Pol AR48260 SDS+ 10 mm for Concrete is a carbide-tipped drill bit designed for use with SDS+ rotary hammer drills. With a 10 mm working diameter and an SDS+ shank, this bit is intended to provide reliable drilling performance in concrete, masonry and similar hard substrates. It is produced for construction, installation and repair tasks where precise, repeatable holes in stone or concrete are required.

Advantages

The SDS+ shank ensures a secure, play-free connection with compatible hammer drills, allowing efficient energy transfer during percussion drilling. The carbide tip improves wear resistance and maintains cutting performance when penetrating abrasive materials. The 10 mm diameter offers a balance between hole size and drilling speed, suitable for common anchoring, dowel and conduit preparation tasks.

Suitable for

• Drilling holes in concrete for anchors and dowels
• Preparing masonry walls for electrical conduit and plumbing
• Installation and repair tasks on stone and block substrates
• Use with SDS+ rotary hammer drills on construction sites and in workshops

Key specifications

• Shank type: SDS+
• Working diameter: 10 mm
• Tip material: carbide
• Intended materials: concrete, masonry, stone
• Tool type compatibility: rotary hammer drills with SDS+ chuck

How to use

Install the drill bit into an SDS+ compatible rotary hammer drill until it locks into place. Select an appropriate hammer or rotary-hammer mode depending on the drill and material hardness. Start drilling at low speed to establish the hole, then apply steady pressure while maintaining drill alignment. Clear debris periodically to avoid overheating and to maintain drilling efficiency. After use, withdraw the bit while the drill is running briefly to eject dust, then store the bit dry to prevent corrosion.

Usage recommendations

Use personal protective equipment including safety glasses and hearing protection when drilling. Match drilling speed and applied pressure to the substrate: excessive force or high speed can shorten tool life. For repeated or deep holes, withdraw the bit regularly to remove debris and allow cooling. Verify compatibility of the SDS+ shank with your rotary hammer before use.