Drill Bit Art-Pol SDS+ 14 mm AR48314 for concrete

Art-Pol SDS+ 14 mm AR48314 for concrete is a carbide-tipped SDS+ drill bit designed for use with SDS+ rotary hammer systems. It is intended for drilling clean, accurate holes in concrete and masonry where a 14 mm diameter is required, offering a balance between drilling speed and hole size for anchor bolts, wall plugs and fastening tasks. The shank profile fits SDS+ chucks for secure engagement and efficient transfer of hammering energy to the cutting head.

Advantages

The 14 mm diameter and carbide tip deliver consistent penetration and wear resistance when working with reinforced concrete and various masonry materials. The SDS+ shank ensures quick bit changes and stable operation in rotary hammer tools. The bit geometry is optimized to evacuate dust from the hole and reduce friction, which supports sustained drilling performance and longer service life under typical professional or DIY conditions.

Suitable for

• Drilling holes for anchor bolts and chemical anchors in concrete
• Fixing wall plugs and mechanical fasteners in masonry
• Installing electrical boxes, conduits and pipe clamps that require 14 mm holes
• General renovation and construction drilling tasks in concrete and brick

Key specifications

• Drill diameter: 14 mm
• Shank type: SDS+
• Tip material: carbide
• Primary use: concrete and masonry
• Suitable tool type: rotary hammer with SDS+ chuck

How to use

Mark the drilling point and secure the work area. Use a rotary hammer set to hammer-drill mode and insert the SDS+ shank fully into the chuck until it locks. Start drilling at low speed to center the bit, then apply steady pressure while allowing the tool’s hammer action to do the work. Periodically withdraw the bit to clear dust and check hole depth. For reinforced concrete, start with steady pressure and avoid excessive sideways force to prevent bit damage.

Usage recommendations

Use appropriate personal protective equipment such as safety glasses, gloves and hearing protection. For deep holes or high drilling volume, remove dust frequently or use vacuum extraction to prolong bit life. Match drill diameter to anchor or plug specifications and ensure the rotary hammer is rated for SDS+ accessories.