Drill Bit Art-Pol SDS+ 16 mm AR48316 for Concrete

The Art-Pol SDS+ 16 mm drill bit AR48316 for Concrete is a rotary hammer accessory made for drilling precise holes in masonry and reinforced concrete. Designed for use with SDS+ chucks, this 16 mm diameter bit is suitable for creating holes for anchors, dowels and fixing elements during renovation and construction work. The bit construction supports rotary hammer action to deliver efficient material removal and controlled drilling in a variety of concrete mixes.

Advantages

The drill bit combines a carbide tip geometry with an SDS+ shank profile to ensure reliable fitment and sustained cutting performance under percussion drilling. Its 16 mm diameter provides a balance between hole size for common anchor systems and manageable drilling effort. The bit is produced to maintain concentricity and reduce wobble, helping to achieve cleaner hole finishes and improved accuracy when installing fasteners in masonry and reinforced structures.

Suitable for

• Drilling anchor and dowel holes in concrete and masonry
• Renovation tasks requiring fixed-size holes for fixtures
• Construction applications with SDS+ rotary hammers
• Installing wall fasteners, electrical boxes and conduit anchors

Key specifications

• Compatible shank type: SDS+
• Diameter: 16 mm
• Intended material: concrete and masonry (including reinforced concrete)
• Tip material: carbide cutting tip for percussion drilling
• Typical application: anchor and dowel hole drilling

How to use

Select an SDS+ rotary hammer with appropriate power and set the hammer/drill to the rotary-percussion mode. Secure the workpiece area, mark the drilling point and start drilling at low speed to establish the position. Apply steady axial pressure while allowing the tool and bit to perform percussion action; periodically withdraw the bit to clear dust and chips for deeper holes. Use appropriate protective equipment and follow the rotary hammer manufacturer's recommendations for drill bit seating and maintenance.

Usage recommendations

For best results, use the 16 mm drill bit with an SDS+ rotary hammer rated for the workpiece material, select the correct drilling mode, and keep the bit clean from debris. When drilling reinforced concrete, use controlled pressure and withdraw frequently to remove material. Replace the bit when carbide wear causes reduced cutting efficiency or excessive wobble.