Drill bit Art-Pol SDS+ 14 mm AR48364 for concrete

The Art-Pol SDS+ 14 mm drill bit AR48364 is a rotary-hammer accessory designed for drilling into concrete and masonry. With a 14 mm cutting diameter and an SDS+ shank format, this bit is intended for producing anchor holes, through-holes and fixing points in reinforced concrete, blockwork and brick. The geometry of the tip and the carbide cutting edges are engineered to resist abrasion during repetitive drilling in construction and renovation work.

Advantages

This SDS+ drill bit delivers consistent 14 mm hole sizing and stable performance when used with compatible SDS+ rotary hammers. The carbide-tipped head improves wear resistance and cutting speed in abrasive substrates, while the flute design aids efficient dust removal to extend bit life. The standardized SDS+ shank ensures secure fit and rapid bit changes on rotary hammer chucks designed for this mounting system.

Suitable for

• Drilling anchor and fixing holes in concrete and reinforced concrete
• Creating through-holes for pipes and conduits in masonry
• Renovation and construction tasks requiring repeated, accurate 14 mm holes

Key specifications

• Cutting diameter: 14 mm
• Shank type: SDS+
• Intended material: concrete, reinforced concrete, masonry, brick
• Tip: carbide cutting tip for improved wear resistance
• Flute design: spiral flutes for dust removal during rotary-hammer drilling

How to use

Fit the SDS+ shank into the rotary hammer chuck until it locks in place. Select the hammer-drilling mode on the tool and position the tip at the required drilling point. Apply steady forward pressure and allow the tool’s percussion action to do the work; avoid excessive lateral force which can damage the bit or the workpiece. Withdraw the bit occasionally to clear dust from the hole, particularly when drilling deep anchors. After use, clean the bit of concrete dust and store it in a dry place to prevent corrosion.

Usage recommendations

Use appropriate personal protective equipment including eye protection, hearing protection and dust mask when drilling concrete. For reinforced concrete, start with light pressure to locate rebar and change to a masonry bit if required; do not attempt to cut through rebar with a standard carbide masonry bit. Match drill speed and hammer settings to the rotary hammer manufacturer’s guidance for 14 mm masonry bits to maximize performance and life.