Drill bit Art-Pol AR48416 SDS+ 16 mm for concrete

Art-Pol AR48416 SDS+ 16 mm drill bit is engineered for efficient drilling in concrete and masonry. The SDS+ shank ensures secure seating in compatible hammer drills, allowing rapid hammer action transfer and reduced slippage. With a 16 mm diameter and tip geometry optimized for percussion drilling, this bit is intended for creating holes for anchors, conduits, and mechanical fastenings in building and renovation projects.

Advantages

The SDS+ connection provides quick and stable tool engagement for uninterrupted drilling. The bit’s flute design facilitates reliable dust evacuation from the hole, improving drilling speed and reducing heat build-up. Hardened steel construction and a wear-resistant tip extend service life under repeated impact loads, helping maintain consistent hole diameter and finish.

Suitable for

• Drilling anchor and fixing holes in concrete and masonry
• Creating passage holes for electrical conduit and plumbing
• Preparatory drilling for mechanical fastenings and inserts
• Professional construction sites and home renovation projects

Key specifications

• Drill diameter: 16 mm
• Shank type: SDS+ compatible
• Intended material: concrete and masonry
• Tip: percussion-optimized geometry for hammer drills
• Flute design: spiral for dust evacuation
• Construction: hardened steel body with wear-resistant tip

How to use

Fit the drill bit into an SDS+ compatible hammer drill until it locks securely. Select the hammer or hammer-drill mode appropriate for concrete or masonry. Mark the drilling point and start at low speed to seat the tip, then increase speed and apply steady axial pressure while allowing the hammer action to drive the bit. Periodically withdraw the bit to clear dust from the hole and prevent clogging; use controlled feed pressure to avoid premature wear. For deep or long holes, drill in stages and clear debris as needed.

Использование — рекомендации

Use appropriate personal protective equipment (safety glasses, ear protection, dust mask) and ensure the drill is set to SDS+ mode. For reinforced concrete, verify rebar location before drilling. Allow the bit to cool between extended runs to maintain tip life and avoid overheating.