UTP 2-Wire Converter Set Atte ETH-2WIRE-A-SET2, 2 pcs, for LAN PoE transmission over 2-wire cabling

The Atte ETH-2WIRE-A-SET2 is a set of two UTP 2-wire converters engineered to transmit LAN data and Power over Ethernet (PoE) across existing two-conductor cabling. Each compact unit converts a standard Ethernet connection into a signal suitable for 2-wire runs and back again at the far end, enabling network connectivity and remote power delivery where standard Ethernet cabling is not available or rewiring is impractical. This converter set is intended for installation in environments that require economical extension of network and PoE to devices such as cameras and access points using existing wiring.

Advantages

The converter set supports simultaneous transmission of Ethernet data and PoE over two-conductor cable, reducing the need to install new CATx cabling. Its plug-and-play design allows integration with typical network equipment without complex configuration. Compact housings make the units easy to place near networking devices or inside enclosures, while the two-piece kit provides both ends required for point-to-point connection. The solution helps lower installation time and material costs by utilizing pre-existing two-wire runs.

Suitable for

• Extending network and PoE to IP cameras over existing two-wire building cabling
• Providing connectivity and power to wireless access points where Ethernet cable is unavailable
• Connecting PoE-enabled devices in retrofit or renovation projects to avoid full rewiring
• Temporary or semi-permanent deployments that rely on simple two-conductor runs

Key specifications

• Function: LAN data and PoE transmission over two-conductor cable
• Kit composition: two converter units for end-to-end connection
• Compatibility: works with PoE-enabled devices compliant with standard Ethernet/PoE equipment
• Installation: inline converters for use with existing two-wire cabling
• Form factor: compact housings suitable for close-to-device placement

How to use

Install one converter at the network switch or PoE injector side by connecting the Ethernet port to the switch and attaching the two-conductor cable to the converter’s two-wire terminals. Place the second converter at the device end and connect the incoming two-wire cable to its terminals, then plug the device into the converter’s Ethernet port. Power and data from the switch or injector are carried over the two-wire link and restored to standard Ethernet at the far end. No additional software configuration is required; verify link status and device power after connections are complete.

Usage recommendations

For reliable operation, use intact, properly insulated two-conductor cable runs and verify cable length and condition to ensure acceptable signal and power delivery. Ensure PoE source capacity matches device power requirements and follow local safety and installation standards when routing and securing wiring. If the two-wire run is long or in electrically noisy environments, test for stable link and consider alternative cabling or repeaters if performance is marginal.