Power drill accessory AWTools AW30451 — dimensions 100×600 mm, weight 550 g

The AWTools AW30451 power drill accessory measures 100×600 mm and weighs 550 g. Made of zinc-plated steel with high-quality welds, this mixing attachment is designed to fit into traditional drills with a 3-jaw chuck via its HEX shank. Two helical ribbons lift and circulate the material to produce a homogenous mix, making the accessory suitable for mixing tile adhesive, plaster, fillers, screed, mortar, cement compounds and paint in workshop and on-site settings.

Advantages

Constructed from zinc-plated steel, the AWTools AW30451 offers resistance to rust and straightforward cleaning after use. The robust welds increase durability under repeated mechanical loading. The two helical ribbons are engineered to pull material upwards and eliminate dead zones during mixing, improving homogeneity. The HEX shank provides a reliable, slip-resistant connection in drills with 3-jaw chucks and ensures straightforward installation and removal.

Suitable for

• Mixing tile adhesive and grout
• Preparing plaster, fillers and putty
• Mixing screed and cement-based compounds
• Stirring paint and primer from cans
• On-site renovation and workshop mixing tasks requiring extended reach

Key specifications

• Length: 600 mm
• Width (mixing head): 100 mm
• Weight: 550 g
• Material: zinc-plated steel
• Shank type: HEX shank for 3-jaw chucks
• Mixing design: two helical ribbons for upward material movement

How to use

Insert the HEX shank into a compatible drill with a 3-jaw chuck and tighten the chuck securely. Place the mixing head into the material container so the ribbons are submerged but not pressed against the container walls. Start the drill at low speed to avoid splashing, then increase speed as needed to achieve a uniform consistency. Move the mixing attachment gently through the material to ensure even circulation and prevent the formation of lumps. After mixing, run the drill briefly at low speed above the mixture to release any trapped material before lifting the attachment out.

Usage recommendations

Use appropriate personal protective equipment such as safety goggles, gloves and a dust mask when mixing powders. Choose drill speeds appropriate to the material viscosity; start slow and increase speed gradually. Clean the mixing attachment immediately after use to prevent material build-up and corrosion despite the zinc plating. Avoid side loads or prying motions that could bend the shaft; use the tool within the drill's recommended torque limits.