3D printing filament AzureFilm FS171-5015 — ASA (Acrylonitrile Styrene Acrylate), Blue, 1.75 mm, 1 kg

AzureFilm FS171-5015 is a 1 kg spool of ASA (Acrylonitrile Styrene Acrylate) 3D printing filament in blue with a 1.75 mm diameter. Manufactured in the EU from high-quality ASA resin, this filament is intended for functional parts and outdoor applications where UV and weather resistance, dimensional stability and mechanical strength are important. The spool is vacuum-sealed with a desiccant sachet to maintain filament dryness and print consistency. Physical spool dimensions: outer diameter about 210 mm, inner opening 60 mm and width 62 mm.

Advantages

ASA offers improved UV and weather resistance compared with standard ABS, while delivering good stiffness, strength and impact resistance for functional prototypes and end-use parts. The filament prints with vibrant, clear color and is formulated to minimize stringing, warping and nozzle clogging. It is compatible with most FDM/FFF 1.75 mm extruders and performs well on commonly used desktop machines when appropriate print settings and enclosure/bed conditions are used.

Suitable for

• Outdoor parts and housings exposed to sunlight and moisture
• Functional prototypes requiring higher temperature and mechanical resistance
• End-use components and enclosures for industrial or consumer devices
• Models where reduced warping and good surface finish are needed

Key specifications

• Material: ASA (Acrylonitrile Styrene Acrylate)
• Color: Blue
• Net filament weight: 1 kg
• Filament diameter: 1.75 mm
• Recommended printing temperature: 240–260 °C (may vary by printer)
• Recommended heated bed temperature: 100–120 °C for best adhesion
• Spool dimensions (approx.): outer Ø 210 mm, inner Ø 60 mm, width 62 mm
• Packaging: vacuum-sealed spool with moisture-absorbing desiccant
• Made in EU

How to use

Load the 1.75 mm ASA filament into a compatible extruder and set the nozzle temperature to within the recommended 240–260 °C range. Use a heated bed set to 100–120 °C for improved adhesion and reduced warping; an enclosed build chamber is recommended when available. Ensure the spool is dry before printing — open the vacuum packaging and, if needed, dry the filament according to your printer or filament dryer instructions. Calibrate extrusion multiplier and first-layer settings to achieve accurate dimensional results and good surface quality.

Usage recommendations

For best results print ASA in a closed printer or with an enclosure, use a heated bed and proper bed adhesion method, and allow slow cooling. Adjust retraction settings to reduce stringing and verify nozzle compatibility with ASA to avoid clogging. Test a small calibration part to fine-tune temperatures and print speeds for your specific machine.