Hole saw BAHCO 3830-30-VIP, single, Ø 30 mm, for drill, metal/plastic/steel/wood

BAHCO 3830-30-VIP is a single-piece 30 mm hole saw designed for use with hand and power drills. Made from Sandflex® bi-metal construction, this hole saw combines durability and cutting performance to create clean round openings in a range of materials including metal, stainless steel, steel, plastic and wood. Supplied as a single unit in a compact box, it is suitable for workshop and on-site tasks where a precise 30 mm hole is required.

Advantages

The bi-metal design provides a balance of toughness and edge retention, extending tool life when cutting through harder materials. The saw’s tooth geometry and high-quality construction reduce vibration and improve cutting speed, delivering smoother cuts and reduced burr formation. Its single-piece format and compatible arbor attachment make it quick to mount on standard drills, while the compact 30 mm diameter is convenient for installations that require a small, accurate opening.

Suitable for

• Cutting 30 mm holes in thin and medium-thickness metal sheets
• Creating openings in stainless steel and structural steel components
• Drilling cable and conduit entries in plastic and PVC panels
• Making precise holes in wood panels, doors or furniture for fittings
• Plumbing and electrical installation where compact round penetrations are needed

Key specifications

• Cutting diameter: 30 mm
• Material type: Sandflex® bi-metal construction for tooth and body
• Suitable workpieces: metal, stainless steel, carbon steel, plastic, wood
• Compatibility: designed for use with hand and power drills and standard hole saw arbors
• Package: supplied as a single unit in a protective box

How to use

Fit the hole saw to a compatible arbor and secure it in the drill chuck. Mark the center of the required hole and, if necessary, drill a small pilot hole to guide the saw. Start drilling at low speed to establish the cut, then increase speed while maintaining steady pressure and alignment. Use moderate feed force and allow the saw to cut without forcing to avoid overheating. Clear swarf periodically to maintain cutting efficiency and finish the hole with light passes for a clean edge.

Usage recommendations

For metal cutting, use cutting fluid or coolant to reduce heat and prolong blade life. When working with stainless steel or thicker materials, operate at lower speeds and apply consistent lubrication. For plastic and wood, higher speeds and minimal pressure usually give better results; secure the workpiece to prevent movement. Inspect the saw before use for wear or damage and replace if teeth are worn or deformed.