Connecting plate Baks BL/BLO100 96mm model 100110 for structural connections

Baks connecting plate BL/BLO100 model 100110 is a metal connector plate with a 96 mm pitch designed for forming rigid structural connections between wooden or metal elements. It is manufactured for use in construction, carpentry and repair tasks where reliable load transfer and precise fastening points are required. The plate’s dimensions and hole spacing allow repeatable assembly of frames, reinforced joints and mounting brackets.

Advantages

The connecting plate delivers consistent mechanical coupling and helps distribute loads across joined members to reduce stress concentrations. Made of stamped metal with pre-punched holes at 96 mm spacing, it enables rapid alignment and fastening with common screws or bolts. Its simple geometry supports straightforward installation and integration into standard framing and bracket assemblies.

Suitable for

• Joining timber beams and studs in frame and truss construction
• Reinforcing joints in furniture, cabinets and shelving
• Connecting thin-walled metal profiles where a flat splice is required
• Repairing or retrofitting existing wooden or metal structures

When it may not be suitable

This connecting plate is intended for mechanical fastening of timber and light metal sections; it may not be suitable where structural calculations demand welded connections, heavy plate splice systems or specialized seismic connectors. For applications with very high dynamic loads, extreme corrosion exposure, or where a specific fire-resistance rating is required, alternative engineered solutions or additional protective treatments should be considered.

Key specifications

• Material: stamped metal plate suitable for mechanical fastening
• Hole spacing: 96 mm center-to-center pattern for alignment
• Typical use: flat connector for joining or reinforcing structural members
• Compatibility: intended for use with screws or bolts appropriate to the substrate
• Form factor: low‑profile rectangular plate for flush mounting

How to use

Position the connecting plate over the joint so that the 96 mm hole pattern aligns with the intended fastener locations in both members. Mark and pre-drill pilot holes into the substrate if working with hardwood or metal, then secure the plate using screws or bolts of adequate diameter and length for the material thickness. Ensure fasteners are driven evenly and that the plate sits flush against the surfaces to maintain proper load transfer and alignment of the joined elements.

What to consider before purchase

• Confirm material thickness and fastener type suitable for your timber or metal substrate
• Verify that the 96 mm hole spacing corresponds to your assembly or framing requirements
• Assess environmental exposure and decide if additional corrosion protection is needed
• Ensure load and safety requirements for the intended application are met by the chosen connector

Usage recommendations

Use matching fasteners with adequate shear and tensile capacity, follow pre-drilling guidelines for hardwoods and metals, and check alignment during installation. For critical structural applications consult applicable building codes or a structural engineer to verify suitability and fastening pattern.