Screwdriver Bit Beast PH2 x 25 mm 1/4" drive 2 pcs

Set of two Beast PH2 screwdriver bits with magnetic tips and depth limiter. Each bit is 25 mm long and has a 1/4" (6.35 mm) hex drive. The limiter prevents screws from being driven too deep into wall surfaces and the magnetic tip helps hold PH2 (Phillips) screws in place. Designed for fastening into plasterboard (drywall) surfaces and compatible with standard 1/4" bit holders and drivers.

Advantages

The magnetic screwdriver bits ensure secure retention of PH2 screws during insertion, while the integrated depth limiter controls fastening depth to avoid overdriving into plasterboard. The 25 mm length provides good accessibility for common drywall fastening tasks, and the 1/4" drive fits standard bit holders and compatible drivers. Supplied as a two-piece set for replacement or convenience.

Suitable for

• Installing fixtures and fittings into plasterboard (drywall)
• Interior assembly and repair work involving PH2 screws
• General DIY tasks where controlled screw depth is required

Key specifications

• Type: PH2 (Phillips) screwdriver bits
• Quantity: 2 pieces
• Length: 25 mm
• Drive: 1/4" (6.35 mm) hex
• Feature: Magnetic tip with depth limiter
• Intended use: Plasterboard (drywall)
• Brand: Beast
• MPN: 9019634
• EAN: 4750959019634

How to use

Fit the PH2 bit into a compatible 1/4" bit holder or driver. Position the screw against the plasterboard surface and engage the magnetic tip to hold the screw. Apply steady pressure and drive the screw until the depth limiter contacts the surface, which prevents further penetration. Replace bits as needed when tip wear reduces fit or magnetic retention.

Usage recommendations

Use these bits with appropriate plasterboard fixings and a driver set to a controlled speed or torque to avoid damaging the board; inspect bits regularly for wear and replace when the PH2 profile no longer fits screws securely.