Bessey woodworking full-surface light bar clamp UNIKLAMP UK 800×80

The Bessey woodworking full-surface light bar clamp UNIKLAMP UK 800×80 is designed to provide even clamping pressure across wide panels and assemblies. With an 800 mm bar and an 80 mm contact face, this clamp distributes force over a large area to reduce marking and ensure flat joints during glue-up and assembly. The lightweight construction and ergonomically shaped handle make positioning straightforward for one-person tasks in workshops and on-site jobs where consistent, full-surface clamping is required.

Advantages

This full-surface clamp offers uniform pressure distribution across the clamping face to minimise surface deformation and improve joint quality. Its long 800 mm bar allows clamping of wide panels without multiple clamps, while the 80 mm contact area ensures stability and alignment. The unit is lightweight for its size, facilitating easier handling and faster setup. The design is suitable for frequent use in carpentry, cabinetry and joinery environments where reliable, flat clamping is essential.

Suitable for

• Gluing wide panels and edge joints in furniture and cabinet making
• Securing assemblies for routing, sanding and trimming
• Clamping veneered or delicate surfaces that require distributed pressure
• On-site carpentry tasks where a lightweight, full-surface clamp is needed

Key specifications

• Bar length: 800 mm
• Clamping face width: 80 mm
• Full-surface contact to distribute pressure
• Lightweight construction for easier handling
• Ergonomic handle for manual tightening and release

How to use

Position the UNIKLAMP so the 80 mm clamping face aligns with the workpiece surface and slide the movable jaw along the 800 mm bar to the required location. Place a protective pad if working with delicate finishes, then tighten using the ergonomically shaped handle until the desired clamping pressure is achieved. For long glue-ups, check even contact along the entire clamping face and adjust as necessary. To release, operate the quick-release or release lever while supporting the workpiece to prevent sudden movement.

Usage recommendations

Use the clamp on clean, flat contact surfaces and consider thin protective strips when clamping finished or veneered panels. Avoid over-tightening; apply only the pressure necessary to achieve a secure, flat joint. Store the clamp in a dry place to maintain smooth sliding on the bar and inspect moving parts regularly for wear.