Bessey body clamp REVO KRE 1250/95 (model KRE125-2K) - adjustable 1250 mm bar, 95 mm throat

The Bessey body clamp REVO KRE 1250/95 is a bar clamp engineered for securing workpieces during assembly, gluing and carpentry tasks. With a 1250 mm bar length and a 95 mm throat depth, this clamp provides steady pressure and accurate alignment for medium-sized panels, frames and components. Its design supports repeatable, hands-free holding to maintain joints and surfaces in position while adhesives set or fasteners are applied.

Advantages

The clamp offers adjustable pressure and a robust sliding mechanism that ensures consistent holding force across the clamping range. Its 1250 mm bar length combined with a 95 mm throat depth allows access to recessed areas and sufficient reach for many joinery tasks. The tool is built for workshop and professional use, delivering stable support and improved work accuracy without unnecessary complexity.

Suitable for

• Gluing and edge-banding of medium-sized panels
• Frame and door assembly
• Carpentry joinery and fitting tasks
• Holding parts during sanding or routing
• General workshop clamping where 95 mm throat is required

Key specifications

• Bar length: 1250 mm
• Throat depth: 95 mm
• Type: adjustable bar clamp / body clamp
• Clamping action: manual with sliding jaw and locking mechanism
• Application: assembly, gluing, carpentry and workshop use

How to use

Position the clamp so the fixed jaw rests against one side of the workpiece and the sliding jaw aligns with the opposite side. Slide the movable jaw along the 1250 mm bar until it contacts the workpiece, then engage the locking mechanism and apply pressure using the handle to reach the required clamping force. Check alignment of edges and joints before fully tightening. Release the clamp by disengaging the lock and sliding the jaw away from the workpiece.

Usage recommendations

For best results, protect delicate surfaces with thin protective pads between the clamp jaws and the workpiece, and avoid over-torquing to prevent material deformation. Use multiple clamps spaced evenly for long or wide panels to distribute pressure uniformly.