Gate lamp BFt Radius 230V without antenna, model 18976

BFt Radius 230V gate lamp (model 18976) is a mains-powered exterior signalling light intended for use with automatic gate and barrier systems. Designed for outdoor installation, the lamp provides clear visual indication of gate movement and status by emitting a bright, steady or flashing signal depending on the control input. Supplied without an antenna, this unit integrates into existing automation setups that require a 230 V signalling device and a compact, weather-resistant fixture for regular use at residential or commercial entrances.

Advantages

The BFt Radius 230V lamp operates directly from a 230 V supply, eliminating the need for separate batteries or low-voltage transformers. Its enclosure is engineered for outdoor conditions and mounting on gate posts or nearby supports, offering reliable signalling in typical external environments. The lamp’s electrical characteristics and installation footprint are compatible with a wide range of automatic gate and barrier controllers, allowing straightforward wiring into standard control circuits. Being supplied without an antenna, it is suitable for systems that use separate radio modules or wired signalling.

Suitable for

• Visual signalling for automated swing or sliding gates
• Barrier systems at vehicle entrances to residential blocks, commercial facilities or industrial sites
• Replacement or retrofit of existing 230 V gate signalling lights

Key specifications

• Supply voltage: 230 V AC
• Purpose: exterior signalling for gate and barrier automation
• Mounting: external post or structure mounting compatible with common gate fittings
• Construction: weather-resistant enclosure suitable for outdoor use
• Connection: wired electrical connection to gate control unit
• Included accessories: unit supplied without antenna

How to use

Install the BFt Radius 230V lamp on a stable external surface close to the gate control unit following local electrical codes. Connect the lamp to the gate controller’s signalling output or to an appropriate switched 230 V circuit; ensure power is isolated during wiring. Configure the gate control to provide the correct signal type (steady or flashing) if the controller supports output modes. After wiring, restore power and verify that the lamp operates in sync with gate opening and closing cycles and that mounting position provides visible signalling to approaching traffic.

Usage recommendations

Use a qualified electrician or certified installer for connection to mains power. Regularly inspect the lamp housing and electrical connections for signs of wear or moisture ingress and replace or service components according to local safety standards. If radio control or remote signalling is required, add a compatible external antenna or radio module as the product is supplied without an antenna.