RCA audio cable BLOW 2×2 RCA male-to-male 1.5 m metal connectors

BLOW RCA audio cable 2×2 male-to-male, length 1.5 m, is designed for analog stereo signal transmission between audio source devices and amplifiers, receivers, speakers or mixers. The cable carries two signal pairs (left and right) using standard RCA plugs with metal connector shells that improve mechanical durability and help maintain reliable contact. Its compact 1.5 m length is intended for short interconnects in home audio systems, studio patching and AV installations where tidy, low-profile wiring is preferred.

Advantages

The metal connector shells increase resistance to wear and provide a stable mechanical connection, while the two-pair design supports standard left/right stereo routing without adapters. The 1.5 m length balances reach and minimal signal loss for short runs, and the RCA male-to-male plugs ensure compatibility with a wide range of consumer and professional audio equipment. Construction focused on reliable contact reduces the risk of noise caused by intermittent connections.

Suitable for

• Connecting CD players, DACs or media players to amplifiers and receivers
• Patch connections between audio interfaces, mixers and monitor controllers in studios
• Linking AV components such as DVD/Blu-ray players and home theater receivers
• Short interconnects in hi‑fi systems where neat cable runs are needed

Key specifications

• Configuration: two signal pairs (stereo)
• Connector type: male RCA to male RCA
• Connector housing: metal shells for improved durability
• Length: 1.5 meters
• Intended signal: analog audio

How to use

Insert each RCA male plug into the corresponding left (usually white or black) and right (usually red) RCA jacks on the source device and the receiving device. Ensure connectors are fully seated to achieve stable contact. Route the cable to avoid sharp bends, tight kinks and close proximity to mains power cords to minimize interference. For best results, power down devices before connecting or disconnecting cables to avoid pops or spikes.

Usage recommendations

For consistent performance, periodically inspect metal connector shells and jack contacts for oxidation or dirt and clean with contact cleaner if needed. Use the 1.5 m length for short runs; if longer distances are required, consider balanced connections or higher-specification interconnects to maintain signal integrity.