Drill bit Bosch 1 618 596 315 for rotary hammer, diameter 10 mm, length 315 mm, 1 pc

Carbide-tipped drill bit Bosch 1 618 596 315 is a long-shank SDS-plus-5 bit designed for rotary hammers. With a 10 mm diameter and 315 mm overall length, this single-piece drill bit is intended for drilling into masonry, concrete and similar mineral materials. The carbide tip and reinforced shank are engineered to withstand the impact action of a rotary hammer and to deliver steady penetration and hole quality for through and deep drilling tasks.

Advantages

The carbide tip provides enhanced hardness and wear resistance for longer life when drilling abrasive substrates. The long 315 mm length allows for deep or through-hole drilling without extension accessories, while the SDS-plus-5 shank ensures secure fitment and efficient transfer of percussive energy from compatible rotary hammers. The bit’s geometry is optimized to remove debris and maintain drilling efficiency in masonry and concrete.

Suitable for

• Drilling through concrete and reinforced concrete where a 10 mm hole is required
• Deep penetration drilling in masonry blocks and brickwork
• Installation tasks that require long-reach holes for anchors, sleeves or through-bolts
• Repair and renovation work involving drilling into stone, mortar and similar materials

Key specifications

• Tip material: carbide-tipped for improved wear resistance
• Shank type: SDS-plus-5 compatible long shank for rotary hammers
• Diameter: 10 mm
• Overall length: 315 mm
• Quantity: 1 piece
• Intended materials: masonry, concrete and similar mineral substrates

How to use

Install the drill bit into the rotary hammer’s SDS-plus chuck until it locks securely. Select the hammer-drilling mode on the tool and position the bit tip at the required drilling point. Apply steady axial pressure and allow the rotary hammer’s percussive action to advance the bit; avoid excessive side loads that can accelerate wear or breakage. For deep holes, periodically withdraw the bit to clear dust and debris and to prevent clogging. After use, clean the bit and store it dry to maintain tip condition.

Usage recommendations

Use personal protective equipment such as safety glasses, hearing protection and dust mask when drilling. Match the bit to a rotary hammer compatible with SDS-plus-5 shanks and ensure the tool’s impact energy rating is suitable for carbide-tipped masonry bits. For reinforced concrete, use controlled feed rate and consider pre-marking rebar locations where possible to avoid sudden impacts.