Hammer drill bit Bosch 1 618 596 233 2.2 cm diameter 1 pc

The Bosch 1 618 596 233 hammer drill bit is a single-piece accessory designed for use with rotary hammers. With a 2.2 cm diameter, this drill bit is intended for efficient drilling in a range of materials where impact drilling is required. Its geometry and material selection are made to withstand the stresses of hammering while delivering controlled penetration and repeatable hole quality.

Advantages

This hammer drill bit provides robust performance under impact load, combining wear resistance with stable cutting geometry for consistent drilling results. The single-piece construction reduces the number of failure points and simplifies handling during insertion and removal. Its 2.2 cm diameter offers a balance between hole size and material removal rate, suitable for many common construction and renovation tasks.

Suitable for

• Drilling holes in concrete and masonry using a rotary hammer
• Installing anchors, dowels and fastening systems
• Professional and DIY renovation where impact drilling is required

Key specifications

• Tool type: hammer (rotary) drill bit
• Diameter: 2.2 cm
• Quantity: 1 piece
• Material: impact-resistant drill steel (designed for hammering applications)
• Compatibility: designed for use with rotary hammers fitted for standard SDS-type or similar chucks (verify fit with your tool)

How to use

Select a rotary hammer with the appropriate chuck and set it to the hammer drilling mode. Mark the drilling location and ensure the workpiece is secure. Fit the 2.2 cm hammer drill bit into the tool chuck according to the tool manufacturer’s instructions and check that it is locked. Start drilling at low speed to establish the pilot point, then apply steady pressure and allow the hammer action to do the cutting. Withdraw the bit periodically to clear dust and maintain cutting efficiency. After use, clean the bit and store it in a dry place.

Usage recommendations

Use personal protective equipment including eye protection, hearing protection and dust mask when drilling. Choose an appropriate drill speed and feed rate; excessive speed or force can shorten tool life. For best results in reinforced concrete or abrasive materials, use periodic withdrawal and flushing of the hole to remove debris and prevent overheating.