Drill Bits Bosch SDS plus-9 RebarCutter 300 mm 2608586999

The Bosch SDS plus-9 RebarCutter Drill Bit (300 mm, model 2608586999) is designed for cutting through rebar embedded in reinforced concrete. It features firmly fixed carbide teeth shaped to maximize cutting speed and wear resistance, a steep 2+2 flute profile for effective dust removal and improved lifetime, and a ventilation hole to dissipate heat and help remove metal chips. The bit is compatible with rotary hammers that use SDS plus holders and must be used in rotation-only mode (without impact). Do not cut through rebar unless approved by a structural engineer.

Advantages

The carbide teeth provide high wear resistance and maintain cutting efficiency over time. The 2+2 flute design ensures optimized dust evacuation and reduced vibration for improved power transfer and drilling speed. The ventilation hole helps reduce heat build-up and facilitates chip removal, contributing to longer tool life and consistent performance. Compatibility with SDS plus holders allows use with a wide range of rotary hammers.

Suitable for

• Cutting rebar in reinforced concrete (only with structural engineer approval)
• Drilling through concrete with embedded metal reinforcement
• Use with SDS plus rotary hammers in rotation-only mode

Key specifications

• Brand: Bosch
• Model / MPN: 2608586999
• EAN: 3165140576727
• Type: SDS plus RebarCutter drill bit
• Length: 300 mm
• Tip: Carbide teeth
• Flute design: steep 2+2 flute for dust removal and vibration optimization
• Compatibility: SDS plus rotary hammers (use without impact)

How to use

Install the drill bit into an SDS plus rotary hammer and set the tool to rotation-only (disable hammer/impact function). Position the bit on the rebar or reinforced concrete surface and apply steady pressure while drilling. Ensure proper cooling and allow chip removal through the ventilation hole and flutes. Stop periodically to clear chips and check the bit condition. Follow all safety procedures and site regulations when working with reinforced concrete and metal.

Usage recommendations

Do not cut through rebar unless you have written approval from a structural engineer. Use the bit in rotation-only mode and avoid impact/hammering. Wear appropriate personal protective equipment, ensure correct tool settings, and inspect the bit regularly for wear or damage to maintain performance and safety.