Rotary Hammer Drill Bosch 2608680263 - SDS‑plus, replacement carbon brush set

Bosch 2608680263 replacement carbon brush set is designed for rotary hammer drills with SDS‑plus systems. The set restores electrical contact within the motor, helping to maintain consistent performance and extend the service life of compatible Bosch rotary hammers. Intended for maintenance and repair, these carbon brushes provide a direct replacement solution to reduce downtime and keep the tool operating according to its original specifications.

Advantages

The replacement carbon brush set offers reliable conductivity and stable contact pressure for continuous motor operation. Components are manufactured to match the form and fit of the original brushes, ensuring straightforward installation and proper seating in the brush holders. Using purpose-made replacement brushes helps maintain torque and rotational speed under load and reduces the risk of arcing and irregular motor behavior. The set supports routine servicing practices and can contribute to predictable maintenance intervals.

Suitable for

• Maintenance and repair of Bosch rotary hammer drills with SDS‑plus chuck systems
• Professional workshops performing electrical motor service
• DIY users replacing worn brushes to restore tool performance
• Preventive maintenance to avoid unscheduled downtime

Key specifications

• Type: replacement carbon brush set for rotary hammer drills
• Compatibility: designed for rotary hammers with SDS‑plus chucks (check tool model compatibility before purchase)
• Material: carbon composite conductor formulated for power tool motors
• Form factor: matched to original brush dimensions to fit standard brush holders
• Function: restores electrical contact between commutator and brush holder to maintain motor performance

How to use

Before replacing brushes, disconnect the tool from power and remove any batteries if cordless. Access the brush holders following the tool manufacturer’s instructions, typically by removing the motor housing cover. Remove the old brushes, inspect the commutator and brush holders for wear or contaminants, and clean as required. Install the new replacement carbon brushes making sure they seat correctly and move freely in the holders. Reassemble the housing and test the tool under light load to confirm normal operation.

Usage recommendations

Replace brushes as soon as excessive sparking, reduced power, or irregular motor noises are observed. Use genuine-form replacement brushes and perform commutator inspection and cleaning during brush change. For safety and optimal results, follow the rotary hammer drill manufacturer’s service instructions and, if unsure, seek assistance from an authorized service center.