Drill bit 6 mm Bosch 2 608 831 007 for rotary hammer, working length 50 mm, 1 pc

Drill bit 6 mm Bosch 2 608 831 007 for rotary hammer, working length 50 mm, 1 pc is a single SDS-plus masonry drill designed for use with compatible rotary hammers. With a nominal diameter of 6 mm and a working length of 50 mm, it is intended for drilling into masonry and common building materials when the hammer function is engaged. The product is supplied as one piece and is optimized for straightforward anchor and fastener installation tasks where a compact hole and precise positioning are required.

Advantages

The SDS-plus shank ensures quick, secure fitting in rotary-hammer chucks and efficient transfer of hammering energy. The 6 mm diameter provides a balance between minimal material removal and sufficient clearance for small anchors and screws. A 50 mm working length offers adequate reach for most light-duty anchoring and mounting applications without excessive flex. Supplied individually, the bit is convenient for replacing worn bits or matching specific job needs.

Suitable for

• Drilling holes for plastic or metal anchors in masonry
• Installing light fixtures and small brackets
• Preparing pilot holes for fasteners in concrete block and brick
• General light-duty construction and renovation tasks

Key specifications

• Diameter: 6 mm
• Working length: 50 mm
• Shank type: SDS-plus
• Quantity: 1 piece
• Intended materials: masonry and common building substrates

How to use

Insert the SDS-plus shank fully into the rotary-hammer chuck until it locks. Select the hammer-drill mode appropriate for masonry work and use a steady, controlled feed rate; allow the tool to do the work rather than forcing the bit. Periodically withdraw the bit to clear dust from the hole, and if drilling deep or hard materials, use short breaks to avoid overheating. Use appropriate drill speed and percussion settings as recommended by the rotary-hammer manufacturer for a 6 mm masonry bit.

Usage recommendations

Wear appropriate personal protective equipment including safety goggles, hearing protection and dust mask when drilling. Match the bit diameter to anchor or fastener specifications and ensure the rotary hammer is set to the correct mode and power for masonry to achieve consistent hole quality and bit life.