Drill bit Bosch 12 mm SDS+ model 2608831032 for hammer drills

Bosch 12 mm SDS+ drill bit model 2608831032 is a carbide-tipped masonry drill designed for use with SDS+ hammer drills. The 12 mm diameter and SDS+ shank ensure secure engagement with compatible rotary hammers, enabling effective drilling in concrete, brick and other masonry materials. This drill bit is intended for standard drilling tasks such as anchor installation, fixture mounting and general construction work where an SDS+ chuck is specified.

Advantages

The SDS+ shank provides fast, secure insertion and reliable torque transfer in hammer drills, reducing slipping during heavy-duty use. A carbide tip improves wear resistance and maintains drilling performance in abrasive masonry. The 12 mm diameter offers a balance between hole size and material removal rate suitable for common anchors and fasteners. The bit is compatible with a wide range of SDS+ rotary hammers, allowing straightforward interchangeability on job sites.

Suitable for

• Drilling holes in concrete for anchors and dowels
• Installing fixtures on brick and block walls
• General construction and renovation drilling tasks
• Use with SDS+ rotary hammer drills

Key specifications

• Diameter: 12 mm
• Shank type: SDS+
• Intended material: concrete, brick, masonry
• Tip material: carbide tip for improved wear resistance
• Typical application: hammer drilling with rotary hammers

How to use

Install the 12 mm SDS+ drill bit into the SDS+ chuck until it locks securely. Select hammer-drill mode on the rotary hammer and set an appropriate rotational speed and hammer action for masonry work. Begin drilling with steady pressure, allowing the tool's hammer action to break material rather than forcing the bit. Withdraw the bit periodically to remove dust and debris and to prevent overheating. For deeper holes, clear the hole with a brush or compressed air before continuing.

Usage recommendations

Use appropriate personal protective equipment, including eye protection, hearing protection and dust mask when drilling masonry. Match anchor and fastener size to the 12 mm hole diameter and follow anchor manufacturer instructions. Replace the bit if the carbide tip becomes worn or if drilling efficiency drops significantly.