SDS-plus-7X Hammer Drill Bits Bosch Expert 6 mm, 200 mm working length, pack of 10

Pack of 10 Bosch Expert SDS-plus-7X hammer drill bits, 6 mm diameter and 200 mm working length, designed for use with SDS-plus rotary hammers. These bits are intended for drilling into concrete, masonry and similar mineral materials. The SDS-plus shank ensures secure fitting and rapid bit changes, while the geometry and material selection provide stable drilling progress and long life under professional and DIY conditions.

Advantages

These Bosch Expert SDS-plus-7X bits combine precise 6 mm diameter holes with a long 200 mm working length, enabling deeper anchoring or through-drilling without changing to extension rods. The SDS-plus system offers fast, tool-free bit changes and reliable retention in compatible hammers. The flute design and carbide tip are optimized for consistent dust removal and efficient impact energy transfer, resulting in steady drilling speed and reduced wear during repetitive tasks.

Suitable for

• Drilling holes in concrete for anchors and dowels
• Installing masonry fasteners in brick and block
• Through-drilling for cable routing in walls and slabs
• Professional trade work and demanding DIY projects

Key specifications

• Diameter: 6 mm
• Working length: 200 mm
• Shank type: SDS-plus compatible
• Pack quantity: 10 pieces
• Intended material: concrete, masonry and similar mineral substrates

How to use

Insert the SDS-plus shank into a compatible rotary hammer until it locks, following the tool manufacturer's instructions for secure mounting. Select appropriate hammer mode and speed for the substrate, start drilling with light pressure to establish the pilot path, then apply steady force while allowing the tool to perform the impact action. Withdraw the bit occasionally to clear debris and ensure effective dust extraction where possible. Replace worn or chipped bits to maintain drilling quality and safety.

Usage recommendations

Use appropriate personal protective equipment such as safety glasses, hearing protection and dust mask when drilling. For prolonged or deep drilling, use a vacuum or dust extraction system and allow bits to cool between long runs. Match drill diameter and working length to anchor or fastener specifications to ensure proper fit and load capacity.