Drill bits Bosch SDS-Quick multi-purpose drill bit 10 mm x 120 mm, for rotary hammer, 1 pc

The Bosch SDS-Quick multi-purpose drill bit 10 mm x 120 mm is a single-piece drill bit designed for use with rotary hammers that accept SDS-Quick shanks. With a 10 mm diameter and 120 mm overall length, this bit is manufactured to handle a range of common drilling tasks where an SDS-Quick interface is required. It is suitable for drilling in masonry, tiles, wood, thin metal and light concrete, and is intended for professional and DIY applications that benefit from reduced tool changeover and a versatile drilling solution.

Advantages

The drill bit combines a standardized SDS-Quick shank with a multi-purpose cutting geometry to enable quick insertion and secure retention in compatible rotary hammers. Its dimensions—10 mm diameter and 120 mm length—offer a balance between reach and rigidity for routine drilling. The design reduces the need for frequent drill bit changes by supporting a variety of materials and multilayered surfaces, helping to streamline work on construction, installation and repair tasks.

Suitable for

• Drilling in masonry and light concrete
• Drilling through ceramic tiles and other finish materials
• Boreholes in wood and wooden fixtures
• Piercing thin metal sheets and light structural metal
• Installation and repair tasks requiring a single SDS-Quick bit for multiple materials

Key specifications

• Diameter: 10 mm
• Overall length: 120 mm
• Shank system: SDS-Quick compatible
• Intended materials: masonry, tiles, wood, thin metal, light concrete, multilayer materials
• Unit quantity: 1 piece

How to use

Fit the drill bit into a rotary hammer that supports SDS-Quick shanks following the tool manufacturer’s instructions until it locks into place. Select the appropriate speed and mode (rotary or hammer action) according to the material to be drilled. For masonry and concrete use hammer mode; for tiles, wood and thin metal use rotary mode or reduced hammer action as recommended for the substrate. Apply steady, even pressure and allow the tool to do the work; withdraw occasionally to clear debris when drilling deep holes. After use, remove the bit and store it clean and dry to maintain performance.

Usage recommendations

Use appropriate personal protective equipment including eye protection and a dust mask when drilling. Match drill mode and speed to the material, and avoid excessive lateral loads to prevent premature wear or breakage. For precise tile drilling, start with a low speed and minimal hammering to avoid cracking. Replace the bit if cutting performance decreases noticeably.