LED ceiling light bousval-électrique LED-PLAFS-12NW 12W IP54 with PIR motion sensor

The bousval-électrique LED ceiling light LED-PLAFS-12NW is a compact 12W LED luminaire with IP54 ingress protection and an integrated PIR motion sensor. Designed for indoor and semi-exposed locations, this ceiling-mounted fixture delivers consistent general illumination while switching on automatically when motion is detected. Its sealed construction helps protect the LED module and electronics from dust and water splashes, making it suitable for corridors, stairwells, utility rooms and sheltered outdoor areas where basic splash protection is required.

Advantages

This LED ceiling light combines low power consumption with automatic presence detection, reducing unnecessary operating hours. The IP54-rated enclosure provides protection against dust and water splashes without the need for additional housings. The integrated PIR sensor simplifies installation because no separate motion detector wiring is required. The compact design and neutral white light output ensure unobtrusive ceiling integration and reliable task illumination in transitional spaces.

Suitable for

• Corridors and passageways in residential and commercial buildings
• Stairwells and landings where automatic lighting improves safety
• Utility rooms, storage areas and basements with occasional occupancy
• Sheltered outdoor areas such as covered entrances or porches with splash exposure

Key specifications

• Rated power: 12 W
• Light source: integrated LED module
• Protection rating: IP54 (dust protected, splashing water resistant)
• Built-in PIR motion sensor for automatic on/off operation
• Mounting: ceiling-mounted compact housing
• Typical application area: indoor and semi-exposed sheltered locations

How to use

Install the fixture on a suitable ceiling surface following local electrical regulations and disconnect mains power before wiring. Connect the supply conductors to the luminaire terminals and secure the housing to the ceiling. Once energized, the integrated PIR sensor will switch the light on when it detects movement within its coverage area and switch it off after the preset absence interval. If required, adjust mounting height and position to optimize motion detection coverage and avoid direct exposure to rain.

Usage recommendations

Place the luminaire at a height and orientation that provide reliable motion detection for the intended coverage zone; avoid installing the sensor facing HVAC vents, reflective surfaces, or heat sources that can cause false triggers. Clean the outer diffuser periodically with a soft, damp cloth and verify that seals and cable entries remain intact to maintain IP54 performance.