Mounting Bracket Celo for 7 mm single stud, pack of 100

Mounting Bracket Celo for 7 mm single stud, pack of 100 is a compact mechanical fixing intended to secure 7 mm anchors or studs in light‑duty installations. Supplied as a pack of 100 pieces, this Celo bracket provides a simple single-point support for routing cables, fastening small fixtures, or attaching interior fittings where a low-profile, reliable connection is needed.

Advantages

The bracket offers consistent geometry for repeatable installation and reliable retention of 7 mm anchors or studs. Its compact size minimizes visibility and material use while providing sufficient support for light fixtures and cable runs. Supplied in a bulk pack of 100, it reduces handling time on site and ensures you have matching parts for multiple fixings. The design facilitates quick placement and mechanical fastening without requiring specialised tools.

Suitable for

• Mounting cable clips and light conduit runs
• Fixing small interior fittings and trim pieces
• Light fixture support where single-point anchoring is acceptable
• Renovation and general construction tasks with 7 mm anchors or studs

Key specifications

• Compatible anchor/stud diameter: 7 mm
• Pack quantity: 100 pieces
• Function: single-point mounting bracket for light‑duty fixings
• Typical applications: cable management, interior fittings, light fixtures
• Form factor: compact, low-profile bracket suitable for confined spaces

How to use

Select a suitable 7 mm anchor or stud for the substrate (masonry, concrete, or hollow wall anchors as appropriate). Position the Celo mounting bracket over the installed anchor or stud so the bracket engages the fixing point. Secure the bracket using the recommended screw or nut for the chosen anchor type until the bracket is held firmly against the surface. Verify alignment and load direction to ensure the bracket supports the intended fixture without undue stress on the anchor.

Usage recommendations

Use the bracket only with appropriate 7 mm anchors or studs and matching fasteners. For loads near the upper capacity of the anchor or where multiple loads or safety concerns exist, consider using multiple brackets or higher‑capacity fixings. Inspect installed brackets for tightness after vibration or settlement and replace any deformed or corroded pieces.