Push Rivets Celo 96IFB — blind/insert fasteners 6×30 mm, hole Ø10 mm, wide head, for cable tie mounting, pack of 100

Celo 96IFB push rivets are blind insert-type fasteners designed for securing cable ties and light components to panels. Each fastener features a 6×30 mm cylindrical body, a wide head that spreads load across the mounting surface, and a central through-hole with a nominal diameter of 10 mm to accept cable ties or small harnesses. Packaged as 100 pieces, these push rivets are intended for use in captive holes in plastic or thin sheet-metal panels where a press-fit blind installation is required.

Advantages

These push rivets provide a simple, tool-minimal installation: they press into preformed holes and form a retained insert that allows a cable tie or threaded element to pass through. The wide head reduces the risk of pull-through and distributes bearing pressure on softer substrates. The blind-fit design permits installation from one side, making them suitable for applications where back access is limited or impossible. Supplied in a bulk pack of 100, they are convenient for batch assembly and maintenance tasks.

Suitable for

• Mounting cable ties and routing harnesses through panel surfaces
• Securing lightweight components to plastic panels or thin sheet metal
• Blind or one-sided installations where rear access is not available
• Repeating assembly tasks in workshops, vehicle interiors, or equipment enclosures

When it may not be suitable

This type of blind insert fastener is not intended for heavy structural loads or high-vibration, high-torque applications. It relies on a captive hole and the surrounding material to hold the press-fit; if the panel material is too brittle, too thin, or lacks a proper recess, retention may be insufficient. For applications requiring electrical bonding, high tensile strength, or sealed connections, alternative fasteners or dedicated hardware should be considered.

Key specifications

• Rivet body diameter: 6 mm
• Rivet body length: 30 mm
• Through-hole nominal diameter: 10 mm
• Head type: wide head for increased bearing area
• Fit type: blind/insert, press-fit installation
• Pack quantity: 100 pieces

How to use

Drill or mould a captive hole of the appropriate diameter in the panel, ensuring the hole edge and surrounding material are free of burrs. Align the rivet with the hole and press it into place until the head sits flush against the panel surface; a push tool, hammer with a soft face, or manual press can be used depending on assembly volume. Thread the cable tie or other insert through the central 10 mm hole and tighten as required. When removal is necessary, the rivet may be pried out carefully or cut away, taking care not to damage the panel.

What to consider before purchase

• Confirm panel hole diameter and thickness are compatible with a 6×30 mm press-fit rivet
• Verify the central 10 mm opening suits the cable ties or components you plan to route
• Assess substrate material (plastic vs. sheet metal) for adequate retention and resistance to pull-out
• Consider environmental factors such as temperature, UV exposure, or chemical contact that may affect material performance

Usage recommendations

Use a proper-sized hole and a controlled pressing method to ensure consistent retention. For repeated installations in production, a bench-mounted press or dedicated insertion tool improves uniformity and reduces workpiece damage. In vehicle or equipment installations, position rivets where loads are distributed and avoid locations exposed to continuous mechanical stress.