Replacement pad COLOP E/20 Colorless – ink pad for COLOP E/20 stamp

Replacement pad COLOP E/20 Colorless is an ink pad designed specifically for COLOP E/20 self-inking stamp housings. The pad is colorless and provides a thin, even layer of ink across the stamp surface without producing visible color on paper. It is intended for use when maintaining moisture levels in the rubber die, refreshing the existing ink reserve, or preparing a stamp for invisible marking tasks where impression color is not required.

Advantages

This replacement pad fits COLOP E/20 housings precisely to ensure consistent contact between the rubber die and the pad. The colorless formulation leaves no visible tint on documents while preserving the rubber surface and restoring inkability. The design simplifies maintenance of self-inking stamps by allowing quick pad replacement to regain clear, consistent impressions and extend the service life of the stamp mechanism.

Suitable for

• Maintaining moisture and ink levels in COLOP E/20 self-inking stamps
• Invisible marking where no visible ink color is desired
• Refreshing worn or dried pads to restore impression quality
• Office and administrative environments that require discreet or non-visible stamping

Key specifications

• Compatibility: designed for COLOP E/20 self-inking stamp housings
• Color: colorless (transparent) ink pad
• Function: provides an even, thin layer of ink without visible color
• Form factor: replacement pad sized to match E/20 stamp insert
• Intended use: maintenance and revitalization of existing stamp ink supply

How to use

Remove the worn pad from the COLOP E/20 housing according to the stamp manufacturer's instructions, then insert the replacement pad until it clicks or seats securely. Ensure the rubber die makes even contact with the pad surface by performing a few test impressions on scrap paper; this allows the ink to distribute evenly across the die. If the pad is being used to maintain moisture rather than produce an impression, apply only as much contact as needed to deliver a thin, uniform transfer of ink to the rubber.

Usage recommendations

Store replacement pads in a cool, dry place away from direct sunlight to preserve ink properties. For best results, use the pad with COLOP E/20 housings only and follow periodic checks of impression quality; replace the pad once impressions become faint or inconsistent. Avoid using solvents or other liquids that are not specified for stamp maintenance, as these can damage the rubber die or alter pad performance.